Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the air conditioning system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK LIN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the LIN communication system is functioning.
      Result 
      Result
      Proceed to
      LIN DTC is not output
      A
      LIN DTC is output
      B



    B.
    GO TO LIN COMMUNICATION SYSTEM (Click here)
    A


    4.CHECK CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN communication system is functioning.
      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output (except Separate Type Yaw Rate Sensor)
      B
      CAN DTC is output (for Separate Type Yaw Rate Sensor)
      C



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)

    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK DTCs OR CHECK SENSOR CHECK CODES THROUGH PANEL DIAGNOSIS
    1. Check DTCs or sensor check codes.

      1. Write down the DTCs or sensor check codes.

    2. Clear the DTCs or sensor check codes.

    3. Check whether the DTCs or sensor check codes recur.

      1. Reproduce the problem symptoms in accordance with the DTCs or sensor check codes that were written down, and check whether the DTCs or sensor check codes recur.

        HINT:
        Refer to the DTC chart when any DTCs or sensor check codes are output.

        Result 
        Result
        Proceed to
        DTC or sensor check code is not output
        A
        DTC or sensor check code is output
        B



    B.
    Go to step 8
    A


    6.REFER TO PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

    2. Result 
      Result
      Proceed to
      Fault not listed in Problem Symptoms Table
      A
      Fault listed in Problem Symptoms Table
      B


    B.
    Go to step 8
    A


    7.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Diagnosis system (Click here)

      1. Panel diagnosis (indicator check)

      2. Panel diagnosis (actuator check)

    2. Panel diagnosis (refrigerant shortage check) (Click here)

    3. Data List/Active Test (Click here)

    4. Terminals of ECU (Click here)

    5. On-Vehicle Inspection

    6. Inspection

    7. Check for DTCs after checking harness and connector (Click here)


    NEXT


    8.ADJUST, REPAIR OR REPLACE

      NEXT


      9.CONFIRMATION TEST

        NEXT

        END