Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2013.08
RM1440E _55 Steering _056147 POWER ASSIST SYSTEMS _0274019 POWER STEERING SYSTEM S

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  DIAGNOSTIC TROUBLE CODE CHART  


HINT:

If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.


Power Steering System
DTC Code Detection Item Return-to-normal See page
C1541 Vehicle Speed Signal After normal confirmation (Click here)
C1544 High Engine Revolution Signal After normal confirmation (Click here)
C15F0 VFC Solenoid Circuit Ignition switch turned to ON again (Click here)
C15F1 Steering Angle Sensor Circuit After normal confirmation (Click here)
U0100 Lost Communication with ECM / PCM "A" After CAN communication system returns to normal condition or ignition switch turned to ON again (Click here)
U0126 Lost Communication with Steering Angle Sensor Module After CAN communication system returns to normal condition or ignition switch turned to ON again (Click here)
U0129 Lost Communication with Brake System Control Module After CAN communication system returns to normal condition or ignition switch turned to ON again (Click here)