Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › from 2013.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274026 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Illumination Circuit  


DESCRIPTION

Power is supplied to the radio and display receiver assembly and steering pad switch illumination when the light control switch is in the tail or head position.

WIRING DIAGRAM

E226612E56
2.76,0.323 2.854,0.469 0.094,0.146 10 false 5 2.688,1.083 2.958,1.229 0.271,0.146 10 false z11 2.688,0.521 2.958,0.667 0.271,0.146 10 false z11 3.75,0.344 3.969,0.49 0.219,0.146 10 false 12 3.708,1.083 3.969,1.229 0.26,0.146 10 false F23 3.719,0.531 3.979,0.677 0.26,0.146 10 false F23 3.188,0.427 3.479,0.573 0.292,0.146 10 false IL+2 2.771,0.885 2.865,1.031 0.094,0.146 10 false 3 3.74,0.885 3.99,1.031 0.25,0.146 10 false 10 3.188,0.99 3.448,1.135 0.26,0.146 10 false -DP 2.75,1.49 4.063,1.969 1.313,0.479 10 false Spiral with Sensor Cable Sub-assembly 0.854,0.906 1.052,1.052 0.198,0.146 10 false LH 0.865,1.74 1.083,1.885 0.219,0.146 10 false RH 0.396,2.365 2.323,2.51 1.927,0.146 10 false Steering Pad Switch Assembly 0.625,3.094 1.448,3.313 0.823,0.219 10 false from Battery 2.729,3.771 3.042,3.917 0.313,0.146 10 false TAIL 3.427,3.229 3.906,3.375 0.479,0.146 10 false PANEL 4.146,3.344 5.521,3.875 1.375,0.531 10 false to Main Body ECU (Multiplex Network Body ECU) 3.417,5.188 3.677,5.333 0.26,0.146 10 false ILL- 2.406,5.573 2.75,5.75 0.344,0.177 10 false F14 2.406,5.74 4.25,5.885 1.844,0.146 10 false Combination Meter Assembly 5.76,6 7.052,6.427 1.292,0.427 10 false Radio and Display Receiver Assembly 3.74,5.073 3.948,5.24 0.208,0.167 10 false 11 5.896,5.073 6.156,5.219 0.26,0.146 10 false ILL- 5.635,4.969 5.729,5.115 0.094,0.146 10 false 5 5.531,5.167 5.875,5.313 0.344,0.146 10 false G35 5.896,0.5 6.188,0.646 0.292,0.146 10 false ILL+ 5.583,0.323 5.76,0.469 0.177,0.146 10 false 10 5.531,0.521 5.833,0.667 0.302,0.146 10 false G36

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

·

The vehicle is equipped with an SRS (Supplemental Restraint System). Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).



PROCEDURE

1.CHECK ILLUMINATION
a.

Check if the illumination for the radio and display receiver assembly, steering pad switch assembly, glove box or others (hazard switch, transmission control switch, etc.) comes on when the light control switch is turned to the tail or head position.

Result:
Result Proceed to
Illumination comes on for all components except steering pad switch assembly. A
Illumination comes on for all components except radio and display receiver assembly. B
Illumination comes on for all components except radio and display receiver assembly and steering pad switch assembly. C
No illumination comes on (radio and display receiver assembly, steering pad switch assembly, hazard switch, glove box, etc.). D




A

2.CHECK HARNESS AND CONNECTOR (BATTERY - SPIRAL CABLE SUB-ASSEMBLY)

B

5.CHECK HARNESS AND CONNECTOR (BATTERY - RADIO AND DISPLAY RECEIVER)

C

GO TO METER / GAUGE SYSTEM

D

GO TO LIGHTING SYSTEM

2.CHECK HARNESS AND CONNECTOR (BATTERY - SPIRAL CABLE SUB-ASSEMBLY)
U150419E02
1.969,2.427 2.219,2.792 true 2.208,2.844 2.583,3.01 0.375,0.167 10 false IL+2 0.135,0.135 0.406,0.302 0.271,0.167 10 false *a 1.5,1.042 1.771,1.208 0.271,0.167 10 false F23

a.

Disconnect the F23 spiral cable sub-assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F23-12 (IL+2) - Body ground Light control switch at tail or head 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Spiral Cable Sub-assembly)



OK

3.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT SPIRAL CABLE SUB-ASSEMBLY
a.

Inspect the spiral cable sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION).


NOTICE:

The spiral cable sub-assembly is an important part of the SRS airbag system. Incorrect removal or installation of the spiral cable sub-assembly may prevent the airbag from deploying. Refer to the pages shown in the brackets.


HINT:



OK

4.INSPECT STEERING PAD SWITCH ASSEMBLY

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY

4.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>REMOVAL).


b.

Inspect the steering pad switch assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>INSPECTION).

HINT:

Only perform "Check the illumination".




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

5.CHECK HARNESS AND CONNECTOR (BATTERY - RADIO AND DISPLAY RECEIVER)
U181077E02
2.313,1.406 2.5,1.625 true 0.146,0.073 0.344,0.281 0.198,0.208 10 false *a 1.542,0.302 1.865,0.479 0.323,0.177 10 false G36 2.49,1.667 2.802,1.844 0.313,0.177 10 false ILL+

a.

Disconnect the G36 radio and display receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G36-10 (ILL+) - Body ground Light control switch at tail or head 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)



OK

6.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - COMBINATION METER ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - COMBINATION METER ASSEMBLY)
a.

Disconnect the G35 radio and display receiver assembly connector.


b.

Disconnect the F14 combination meter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G35-5 (ILL-) - F14-11 (ILL-) Always Below 1 Ω
G35-5 (ILL-) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR