Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › from 2013.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274026 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Steering Pad Switch Circuit  


DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly.

If there is an open in the circuit, the radio system cannot be operated using the steering pad switch assembly.

If there is a short in the circuit, the resulting condition is the same as if a switch were continuously pressed. Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch assembly, and the radio and display receiver assembly itself cannot function.

WIRING DIAGRAM

E225878E81
0.26,1.156 0.813,1.333 0.552,0.177 10 false Volume- 0.333,4.656 0.781,4.833 0.448,0.177 10 false Voice* 1.031,4.656 1.615,4.833 0.583,0.177 10 false Off Hook 1.24,5.573 3.177,5.75 1.938,0.177 10 false Steering Pad Switch Assembly 1.802,4.656 2.375,4.833 0.573,0.177 10 false On Hook 1.031,1.156 1.625,1.333 0.594,0.177 10 false Volume+ 2.958,1.156 3.198,1.333 0.24,0.177 10 false Up 5.01,0.594 5.302,0.771 0.292,0.177 10 false AU1 5,1.542 5.302,1.719 0.302,0.177 10 false EAU 5.01,2.5 5.302,2.677 0.292,0.177 10 false AU3 5.01,3.771 5.302,3.948 0.292,0.177 10 false AU2 6.281,0.677 6.656,0.854 0.375,0.177 10 false SW1 6.281,1.635 6.667,1.813 0.385,0.177 10 false SWG 6.281,2.583 6.656,2.76 0.375,0.177 10 false SW3 6.281,3.854 6.656,4.031 0.375,0.177 10 false SW2 5.823,4.292 6.198,4.469 0.375,0.177 10 false G29 1.99,1.156 2.375,1.333 0.385,0.177 10 false Down 0.5,2.104 0.792,2.281 0.292,0.177 10 false Left 1.229,2.104 1.594,2.281 0.365,0.177 10 false Right 2.823,2.104 3.177,2.281 0.354,0.177 10 false Enter 4.521,0.708 4.781,0.885 0.26,0.177 10 false z11 4.521,2.625 4.771,2.802 0.25,0.177 10 false z11 4.521,3.875 4.781,4.052 0.26,0.177 10 false z11 4.573,0.5 4.75,0.677 0.177,0.177 10 false 10 4.604,3.677 4.781,3.854 0.177,0.177 10 false 9 4.604,1.458 4.698,1.635 0.094,0.177 10 false 7 4.583,2.406 4.677,2.583 0.094,0.177 10 false 8 5.531,0.708 5.833,0.885 0.302,0.177 10 false F23 6.042,0.583 6.219,0.76 0.177,0.177 10 false 21 6.042,1.542 6.219,1.719 0.177,0.177 10 false 23 6.042,2.5 6.219,2.677 0.177,0.177 10 false 24 6.042,3.771 6.219,3.948 0.177,0.177 10 false 22 5.615,1.458 5.708,1.635 0.094,0.177 10 false 3 5.615,0.5 5.708,0.677 0.094,0.177 10 false 6 5.615,2.406 5.708,2.583 0.094,0.177 10 false 4 5.615,3.677 5.708,3.854 0.094,0.177 10 false 5 2.313,3.385 3.188,3.563 0.875,0.177 10 false MODE/HOLD 2.031,2.104 2.385,2.281 0.354,0.177 10 false Back 4.729,4.302 5.667,4.792 0.938,0.49 10 false Spiral Cable Sub-assembly 5.802,4.469 7.146,4.802 1.344,0.333 10 false Radio and Display Receiver Assembly 4.521,1.667 4.781,1.844 0.26,0.177 10 false z11 5.531,1.656 5.833,1.833 0.302,0.177 10 false F23 5.531,2.604 5.833,2.781 0.302,0.177 10 false F23 5.531,3.875 5.833,4.052 0.302,0.177 10 false F23 0.406,6.229 3.344,6.406 2.938,0.177 10 false *: Voice recognition function is not supported.

CAUTION / NOTICE / HINT

NOTICE:

The vehicle is equipped with an SRS (Supplemental Restraint System). Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

1.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY
U181087E02
1.615,1.896 1.021,2.438 true 1.792,1.896 1.625,2.479 true 1.948,1.896 2.083,2.49 true 2.063,1.906 2.667,2.458 true 1.583,0.635 1.927,0.802 0.344,0.167 10 false G29 0.708,2.479 1.083,2.646 0.375,0.167 10 false SW1 2.073,2.542 2.448,2.708 0.375,0.167 10 false SWG 1.302,2.542 1.677,2.708 0.375,0.167 10 false SW2 2.729,2.479 3.104,2.646 0.375,0.167 10 false SW3 0.125,0.083 0.417,0.302 0.292,0.219 10 false *a

a.

Disconnect the G29 radio and display receiver assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G29-21 (SW1) - G29-23 (SWG) No switch pushed 95 to 105 kΩ
Up switch pushed Below 2.5 Ω
Down switch pushed 313 to 345 Ω
Volume+ switch pushed 950 to 1050 Ω
Volume- switch pushed 2955 to 3265 Ω
G29-22 (SW2) - G29-23 (SWG) No switch pushed 95 to 105 kΩ
MODE/HOLD switch pushed Below 2.5 Ω
On hook switch pushed 313 to 345 Ω
Off hook switch pushed 950 to 1050 Ω
Voice switch pushed* 2955 to 3265 Ω
G29-24 (SW3) - G29-23 (SWG) No switch pushed 95 to 105 kΩ
Enter switch pushed Below 2.5 Ω
Back switch pushed 313 to 345 Ω
Right switch pushed 950 to 1050 Ω
Left switch pushed 2955 to 3265 Ω



*: Voice recognition function is not supported.

Text in Illustration
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)


OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT STEERING PAD SWITCH ASSEMBLY
2.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>REMOVAL).


b.

Inspect the steering pad switch assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>INSPECTION).



OK

3.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

3.INSPECT SPIRAL CABLE SUB-ASSEMBLY
a.

Inspect the spiral cable sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION).

NOTICE:

The spiral cable sub-assembly is an important part of the SRS airbag system. Incorrect removal or installation of the spiral cable sub-assembly may prevent the airbag from deploying. Refer to the pages shown in the brackets.


HINT:




OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (RADIO AND DISPLAY RECEIVER - SPIRAL CABLE SUB-ASSEMBLY)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY