Home › Vehicle Exterior › DOOR / HATCH › HOOD › from 2013.08
RM1440E _59 Vehicle Exterior _056168 DOOR / HATCH _0274183 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B246460E02
0.229,0.125 1.625,0.573 1.396,0.448 12 Centerring Bolt 1.99,0.115 3.333,0.594 1.344,0.479 12 Standard Bolt

HINT:
·

Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

·

The specified torque for standard bolts is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 52119A 3.REMOVE FRONT BUMPER COVER (w/o TOYOTA Parking Assist-sensor System)

Hide 52119A 4.REMOVE FRONT BUMPER COVER (w/ TOYOTA Parking Assist-sensor System)

Hide 5.ADJUST HOOD SUB-ASSEMBLY

a.

Adjust the hood position.

i.
B237105

Loosen the 4 hinge bolts on the hood sub-assembly.


ii.

Move the hood sub-assembly and adjust the clearance between the hood sub-assembly and front fender.


iii.

Tighten the 4 hinge bolts on the hood sub-assembly after the adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)



b.

Adjust the height of the front end of the hood sub-assembly using the cushion rubbers.

i.
B237106

Adjust the cushion rubbers so that the hood sub-assembly and front fender are aligned.

HINT:

Raise or lower the front end of the hood sub-assembly by turning the 2 cushion rubbers.




c.

Adjust the hood lock .

i.
B237107

Loosen the 3 bolts.


ii.

Adjust the hood lock assembly and tighten the 3 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


iii.

Check that the striker can engage with the hood lock assembly smoothly.



Hide 52119A 6.INSTALL FRONT BUMPER COVER (w/ TOYOTA Parking Assist-sensor System)

Hide 52119A 7.INSTALL FRONT BUMPER COVER (w/o TOYOTA Parking Assist-sensor System)