VEHICLE STABILITY CONTROL SYSTEM > VSC SPORT Indicator Light Remains ON |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | |
| 2.CHECK IF BRAKE ACTUATOR ASSEMBLY CONNECTOR IS SECURELY CONNECTED |
Check if the skid control ECU (brake actuator assembly) connector is securely connected.
|
| ||||
| OK | |
| 3.CHECK BATTERY |
Check the battery voltage.
|
| ||||
| OK | |
| 4.READ VALUE USING GTS (VSC SPORT SWITCH) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Select the Data List using the GTS (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Sports Mode | VSC SPORT mode / Normal or Sports | Normal: Normal mode Sports: VSC SPORT mode | - |
Using the GTS, check that the switch condition displayed on the GTS changes according to VSC SPORT switch operation.
|
| ||||
| OK | |
| 5.INSPECT COMBINATION METER ASSEMBLY |
Perform an Active Test of the combination meter assembly (meter CPU) using the GTS (Click here).
Check the combination meter assembly.
|
| ||||
| OK | ||
| ||
| 6.INSPECT VSC SPORT SWITCH |
Remove the VSC SPORT switch (Click here).
Inspect the VSC SPORT switch (Click here).
|
| ||||
| OK | |
| 7.CHECK HARNESS AND CONNECTOR (BRAKE ACTUATOR ASSEMBLY - VSC SPORT SWITCH) |
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A5-27 (CSW2) - D35-1 | Always | Below 1 Ω |
| A5-27 (CSW2) - Body ground | Always | 10 kΩ or higher |
| D35-8 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||