Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR › from 2016.06
RM2090E _54 Brake _060684 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0297621 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  REMOVAL  


PROCEDURE

Hide 45111 1.REMOVE STEERING WHEEL ASSEMBLY

Hide 2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 55318C 4.REMOVE INSTRUMENT SIDE PANEL (w/o Knee Airbag)

Hide 55606 5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

Hide 6.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 55461A 7.REMOVE INSTRUMENT PANEL ORNAMENT (w/ Large Ornament Panel)

Hide 55405B 8.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Large Ornament Panel)

Hide 55422 10.REMOVE UPPER INSTRUMENT PANEL METER ORNAMENT

Hide 45289A 11.REMOVE STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)

Hide 12.REMOVE LOWER STEERING COLUMN COVER

Hide 45286 13.REMOVE UPPER STEERING COLUMN COVER

Hide 14.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 89245B 15.REMOVE STEERING SENSOR

NOTICE:
·

Remove the steering sensor from the spiral cable sub-assembly only when replacing it or the steering sensor.

·

Do not rotate the center section of the steering sensor, as it may deviate from the steering sensor neutral point.

·

When replacing the spiral cable sub-assembly: (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL)



a.
B313958E01
1.903,0.125 2.089,0.286 0.186,0.161 10 *1 3.175,0.574 3.361,0.735 0.186,0.161 10 *2 1.38,0.398 1.566,0.559 0.186,0.161 10 *2 1.927,0.933 2.113,1.094 0.186,0.161 10 *1 2.098,0.258 2.442,0.674 false 2.098,1.026 2.458,1.17 false 0.784,0.854 1.365,0.498 false 2.909,0.939 3.169,0.703 false

Disengage the 6 claws, 2 pins and 2 guides to remove the spiral cable sub-assembly from the steering sensor.

NOTICE:

Do not damage the guide and claw.


Text in Illustration
*1 Guide
*2 Pin