Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(for 2NR-VE) › from 2015.08
RM19Y0E _52 Drivetrain _002984 CLUTCH _0197228 CLUTCH MASTER CYLINDER(for 2NR-VE) A

CLUTCH  CLUTCH MASTER CYLINDER(for 2NR-VE)  INSTALLATION  


PROCEDURE

Hide 31410 1.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

a.

Install the clutch master cylinder assembly with the bolt and nut.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


b.

Apply MP grease to the pin.


c.

Install the clutch master cylinder push rod clevis with the wave washer, pin and clip.


Hide 55106 2.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for LHD)

Hide 44610 3.INSTALL BRAKE BOOSTER ASSEMBLY (for LHD)

Hide 4.INSTALL CLUTCH PEDAL BRACKET (for RHD)

a.

Install the clutch pedal bracket with the nut and 2 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 31481 5.INSTALL CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

a.
C334357C01
1.771,2.938 2.083,3.135 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench (10 mm), install the clutch master cylinder to flexible hose tube.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)):

13.4 N*m (137 kgf*cm, 10 ft.*lbf)




Hide 31481A 6.CONNECT NO. 1 CLUTCH HOSE

a.

Connect the No. 1 clutch hose.


Hide 84520 7.INSTALL CLUTCH START SWITCH ASSEMBLY (for LHD)

Hide 8.CONNECT CONNECTOR (for RHD)

a.

Connect the connector to the clutch start switch assembly.


b.

Attach the 2 harness clamps to the clutch pedal bracket.


Hide 84340 9.INSTALL STOP LIGHT SWITCH ASSEMBLY (for LHD)

Hide 55545 10.INSTALL FUSE BOX OPENING COVER (for LHD)

Hide 83100 11.INSTALL COMBINATION METER ASSEMBLY (for LHD)

Hide 45250 12.INSTALL STEERING COLUMN ASSEMBLY

Hide 13. FILL RESERVOIR WITH BRAKE FLUID

Hide 31301 15.INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY

Hide 16.INSPECT AND ADJUST BRAKE PEDAL SUB-ASSEMBLY (for LHD)

Hide 17.INSPECT FOR CLUTCH FLUID LEAK

Hide 18.CHECK FLUID LEVEL IN RESERVOIR

Hide 51443 19.INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)