| Theft deterrent system cannot be set
|
Immobiliser system "security indicator light does not blink"
|
|
| ACC signal circuit
|
|
| IG signal circuit
|
|
| Door unlock detection switch circuit
|
|
| Door courtesy switch circuit
|
|
| Back door courtesy switch circuit
|
|
| Engine hood courtesy switch circuit
|
|
| If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) (for LHD)
|
|
| If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) (for RHD)
|
|
| Security indicator light does not blink when theft deterrent system is set
|
Immobiliser system "security indicator light does not blink"
|
|
| Theft deterrent system cannot be unset by turning the READY ON.
|
Replace the main body ECU (multiplex network body ECU) (for LHD)
|
|
| Replace the main body ECU (multiplex network body ECU) (for RHD)
|
|
| Theft deterrent system can be set even when door is open
|
Door courtesy switch circuit
|
|
| Back door courtesy switch circuit
|
|
| If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) (for LHD)
|
|
| If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) (for RHD)
|
|
| Theft deterrent system can be set even when hood is open
|
Engine hood courtesy switch circuit
|
|
| Vehicle horns do not sound while theft deterrent system is in alarm sounding state
|
Horn circuit
|
|
| Hazard warning lights do not flash while theft deterrent system is in alarm sounding state
|
Combination meter assembly
|
|
| If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) (for LHD)
|
|
| If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) (for RHD)
|
|
| Security horn does not sound while theft deterrent system is in alarm sounding state*1
|
Security horn circuit
|
|
| Theft warning siren does not sound while theft deterrent system is in warning operation*2
|
Theft Warning Siren Circuit
|
|
| Hazard warning lights flash even when theft deterrent system is not set
|
Combination meter assembly
|
|
| If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) (for LHD)
|
|
| If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) (for RHD)
|
|
| The vehicle does not enter the alarm sounding state in accordance with intrusion sensor operation*2
|
Intrusion sensor circuit
|
|
| Intrusion sensor cancel switch circuit
|
|
| If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU)
|
|
| Intrusion sensor cancel switch does not operate*2
|
Intrusion sensor cancel switch circuit
|
|
| If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU)
|
|
| Glass breakage sensor does not operate*2
|
Glass breakage sensor circuit
|
|
| The vehicle does not enter the alarm sounding state as the auxiliary battery is reconnected
|
Check the auxiliary battery
|
|
| Power Source Circuit
|
|
| The warning sounds itself
|
Improper Operation
|
|