The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission control cable assembly removal/installation are shown below.
*1: When performing learning using the GTS.
When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.
Touching high-temperature areas such as the engine and exhaust pipe could result in burns.
1.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to neutral, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>8NR-FTS BATTERY>REMOVAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
28800
4.REMOVE BATTERY
5.REMOVE REAR CONSOLE BOX ASSEMBLY
53141F
6.REMOVE RADIATOR COVER
17751
7.REMOVE NO. 1 AIR CLEANER INLET
17705
8.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17701
9.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
89661
10.REMOVE ECM
74404A
11.REMOVE BATTERY CLAMP SUB-ASSEMBLY
57533B
12.REMOVE FRONT FLOOR CENTER BRACE
17410
13.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
58151
14.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
Remove 3 nuts and front No. 1 floor heat insulator from the vehicle body.
33820B
15.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
Remove the clip to disconnect the transmission control select cable from the floor shift shift lever assembly.
Disconnect the transmission control shift cable from the floor shift shift lever assembly.
Disengage the 2 claws and disconnect the transmission control cable assembly from the floor shift lever assembly.
Remove the 2 clips A to disconnect the transmission control cable assembly from the manual transaxle assembly.
Remove the 2 clips B to disconnect the transmission control cable assembly from the control cable bracket assembly.
Remove the nut.
Disengage the guide and disconnect the transmission control cable assembly from the vehicle body.
Remove the 2 nuts and transmission control cable assembly from the vehicle body.