Home › Drivetrain › K114 (MULTIDRIVE / CVT) › OIL COOLER
RM32H0E _52 Drivetrain _059616 K114 MULTIDRIVE / CVT _0292454 OIL COOLER A

K114 MULTIDRIVE / CVT  OIL COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the oil cooler removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)

PROCEDURE

Hide 51410 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51444A 2.REMOVE REAR ENGINE UNDER COVER LH

Hide 3.DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

Hide 4.DRAIN ENGINE COOLANT

Hide 53141F 6.REMOVE RADIATOR COVER

Hide 17751 7.REMOVE NO. 1 AIR CLEANER INLET

Hide 17705 8.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 17701 9.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 16267 10.DISCONNECT NO. 3 WATER BY-PASS HOSE

a.
C365134C01
3,1 2.417,0.729 true 3.031,0.896 3.281,1.083 0.25,0.188 10 true *1
*1 No. 3 Water By-pass Hose


Slide the clip and disconnect the No. 3 water by-pass hose from the oil cooler.


Hide 16282 11.DISCONNECT NO. 5 WATER BY-PASS HOSE

a.
C365135C01
0.583,1.583 1.104,0.969 true 0.479,1.615 0.74,1.813 0.26,0.198 10 true *1
*1 No. 5 Water By-pass Hose


Slide the clip and disconnect the No. 5 water by-pass hose from the oil cooler.


Hide 32943S 12.DISCONNECT NO. 1 TRANSMISSION OIL COOLER HOSE

a.
C365136C01
1.031,1.531 1.781,1.531 true 0.854,1.448 1.031,1.635 0.177,0.188 10 true *1
*1 No. 1 Transmission Oil Cooler Hose


Slide the clip and disconnect the No. 1 transmission oil cooler hose from the oil cooler.


Hide 32943U 13.DISCONNECT NO. 2 TRANSMISSION OIL COOLER HOSE

a.
C365137C01
2.177,1.208 2.917,0.75 true 2.938,0.646 3.156,0.844 0.219,0.198 10 true *1
*1 No. 2 Transmission Oil Cooler Hose


Slide the clip and disconnect the No. 2 transmission oil cooler hose from the oil cooler.


Hide 33493B 14.REMOVE OIL COOLER

a.
C365138

Remove the 2 bolts and oil cooler from the transmission oil cooler bracket.


Hide 32913F 15.REMOVE TRANSMISSION OIL COOLER BRACKET

a.
C365139

Remove the 3 bolts and transmission oil cooler bracket from the continuously variable transaxle assembly.