The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission revolution sensor removal/installation are shown below.
*1: When performing learning using the GTS.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>3ZR-FAE BATTERY>REMOVAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
28800
3.REMOVE BATTERY
11212
4.REMOVE NO. 2 CYLINDER HEAD COVER
53141F
5.REMOVE RADIATOR COVER
17751
6.REMOVE NO. 1 AIR CLEANER INLET
17705
7.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
8.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
89661
9.REMOVE ECM
74404A
10.REMOVE BATTERY CLAMP SUB-ASSEMBLY
89413P
11.REMOVE TRANSMISSION REVOLUTION SENSOR (NIN)
Disconnect the connector.
Remove the bolt and transmission revolution sensor (NIN) from the continuously variable transaxle assembly.
Remove the O-ring from the transmission revolution sensor (NIN).
89413M
12.REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT)
Disconnect the connector.
Remove the bolt and transmission revolution sensor (NOUT) from the continuously variable transaxle assembly.
Remove the O-ring from the transmission revolution sensor (NOUT).
89413N
13.REMOVE TRANSMISSION REVOLUTION SENSOR (NT)
Disconnect the connector.
Remove the bolt and transmission revolution sensor (NT) from the continuously variable transaxle assembly.
Remove the O-ring from the transmission revolution sensor (NT).