Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY › 2016.10–2018.05
RM32H0E _59 Vehicle Exterior _060017 DOOR / HATCH _0295664 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RHD and LHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 53630 1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)

a.

Pass the hood lock control cable assembly into the engine compartment.


b.

Engage the grommet.

B450731C01
2.813,0.615 3.781,0.615 true 2.615,0.521 2.927,0.677 0.313,0.156 10 false *a
*a Grommet - -



c.

Connect the hood lock control cable assembly to the clamps.


Hide 53630 2.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)

a.

Pass the hood lock control cable assembly into the engine compartment.


b.

Engage the grommet.

B450732C01
4.573,0.563 5.26,0.563 true 5.333,0.458 5.656,0.719 0.323,0.26 10 false *a
*a Grommet - -



c.

Connect the hood lock control cable assembly to the clamps.


Hide 53601 3.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.

Install the hood lock control lever sub-assembly to the hood lock control cable assembly.


Hide 53632 4.INSTALL HOOD LOCK CONTROL CABLE HOLDER

a.
B460892C03
0,0 0,0 false
V113147

Install in this Direction


Engage the claw to install the hood lock control cable holder as shown in the illustration.


Hide 53601 5.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 53510 6.INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)

a.

Apply MP grease to the sliding areas of the hood lock assembly.


b.

Connect the hood lock control cable assembly to the hood lock assembly.


c.

Install the hood lock assembly with the 2 bolts and hood lock bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 53510 7.INSTALL HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)

Hide 16561C 9.INSTALL NO. 1 RADIATOR TO SUPPORT SEAL

Hide 53117C 10.INSTALL NO. 1 RADIATOR GRILLE RETAINER

Hide 53876A 11.INSTALL FRONT FENDER LINER LH

HINT:

Use the same procedure as for the RH side.

Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>INSTALLATION


Hide 12.INSTALL BODY ROCKER PANEL MOULDING ASSEMBLY

Hide 75602A 13.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY

Hide 14.INSTALL FRONT BUMPER ASSEMBLY

Hide 15.INSTALL FRONT WHEEL

Hide 53301 16.ADJUST HOOD SUB-ASSEMBLY