Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM › from 2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0404351 PANORAMIC VIEW MONITOR SYSTEM T

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

The following inspection procedure of the panoramic view monitor system is described on the assumption that the navigation system is normal. If the navigation system has any malfunction, first proceed with troubleshooting of the navigation system.

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.



HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


General
Symptom Suspected Area Link
Display does not switch when the panoramic view monitor switch is pressed. Refer to "Panoramic View Screen Description" in system description Click here
Proceed to "ECU Power Source Circuit" Click here
Diagnostic mode - Signal connection check (CAMERA SW check) Click here
Replace parking assist ECU Click here
Display does not switch to the panoramic view and rear view screen, or narrow rear view screen when the shift lever is in R. Diagnostic mode - Signal connection check (SHIFT check) Click here
Replace parking assist ECU Click here
Image not displayed on the panoramic view and rear view screen, or narrow rear view screen when the shift lever is in R. Proceed to "Image from Camera for Panoramic View Monitor is Abnormal" Click here
Display does not switch to the panoramic view and wide front view screen or the two-side view screen when the panoramic view monitor switch is pressed. Proceed to Description "Panoramic View Monitor Screen Display Conditions" Click here
Diagnostic mode - Signal connection check (CAN check) Click here
Diagnostic mode - Signal connection check (CAMERA SW check) Click here
Replace parking assist ECU Click here
Image not displayed on the panoramic view and wide front view screen or the two-side view screen when the panoramic view monitor switch is pressed. Proceed to "Image from Camera for Panoramic View Monitor is Abnormal" Click here

Display Malfunction
Symptom Suspected Area Link
Objects not displayed correctly on the panoramic view monitor screen (color, distorted image). Proceed to "Image from Camera for Panoramic View Monitor is Abnormal" Click here
Distorted display on panoramic view screen. Camera view adjustment (calibration) Click here
Replace parking assist ECU Click here
Parking lines do not match at front and rear on panoramic view screen. Camera view adjustment (calibration) Click here
Replace parking assist ECU Click here
Partial black screen on panoramic view screen. Proceed to "Image from Camera for Panoramic View Monitor is Abnormal" Click here
Camera view adjustment (calibration) Click here
Replace parking assist ECU Click here
Area displayed differs from the actual area. Ensure no door is opened -
Camera view adjustment (calibration) Click here
Replace parking assist ECU Click here

Switch Function
Symptom Suspected Area Link
Panoramic view monitor switch night illumination does not illuminate. Inspect panoramic view monitor switch Click here
Harness or connector -
The touch function of the screen does not operate for any system. Proceed to "Touch Panel Switch does not Function" Click here
Replace parking assist ECU Click here
Radio and display receiver assembly Click here
The touch function of the screen does not operate for the panoramic view monitor system. Replace parking assist ECU Click here
Radio and display receiver assembly Click here

Panoramic View Monitor System Function
Symptom Suspected Area Link
When the vehicle speed increases in the automatic display mode, the panoramic view and wide front view screen or the two-side view screen remains displayed, without switching to the navigation screen. Replace parking assist ECU Click here
The screen display timer function does not operate if the manual display mode is selected. Refer to "Panoramic View Screen Description" in system description Click here
Replace parking assist ECU Click here
The estimated course lines do not match the vehicle width extension lines when the steering wheel points straight ahead. Check the steering wheel installation angle Click here
Adjust steering angle Click here
Camera view adjustment (calibration) Click here
Replace parking assist ECU Click here
Estimated course lines stop moving before the steering wheel is turned fully left. Steering angle setting (calibrate stored maximum steering angle) Click here
"!" is displayed and estimated course lines are not displayed. Check if the luggage compartment door is not open -
Replace parking assist ECU Click here
Replace radio and display receiver assembly Click here
Estimated course lines are not displayed. Check the panoramic view monitor screen display mode settings (Check if the estimated course lines display is set to off) Click here
Replace parking assist ECU Click here
"!" is displayed. Store the steering angle sensor steering neutral point Click here
"!" remains displayed after the steering neutral point is stored. Adjust steering angle Click here
Replace steering sensor Click here
Replace parking assist ECU Click here
"!" is displayed and all the buttons on the screen are grayed out. Camera view adjustment (calibration) Click here
Adjust steering angle Click here
Refer to Navigation System Click here
"!" is displayed and all the buttons on the screen are grayed out even after parking assist ECU initialization has been completed. Replace parking assist ECU Click here
Refer to Navigation System Click here
Guide lines and buttons are not displayed on the panoramic view and rear view screen display screen. Check if the luggage compartment door is not open -
Check if the luggage compartment light turns on and off normally (If not, refer to Lighting System (Interior) - Problem Symptoms Table) Click here
Replace parking assist ECU Click here
"CHK" is displayed for an item on the Vehicle Signal Check screen. Diagnostic mode - Signal connection check Click here
Blind spots in image. Ensure no door is opened -
Camera view adjustment (calibration) Click here
Camera boundary lines are poorly connected. Camera view adjustment (calibration) Click here
Estimated course lines are displaced. Camera view adjustment (calibration) Click here
Adjust steering angle Click here
All buttons on the panoramic view monitor are continuously grayed out Refer to Navigation System Click here