84540
1.INSTALL PARK/NEUTRAL POSITION SWITCH
Temporarily install the park/neutral position switch to the continuously variable transaxle with the 2 bolts.
Install the lock nut and lock plate to the park/neutral position switch.
Temporarily install the control shaft lever.
Turn the control shaft lever clockwise until it stops, and then from that position turn it counterclockwise by 2 notches to set it to the N position.
Remove the control shaft lever.
| *a | Neutral Basic Line |
| *b | Protrusion |
Align the protrusion with the neutral basic line.
Hold the park/neutral position switch in that position and tighten the 2 bolts.
Using a screwdriver, bend down the tabs of the lock plate.
Install the control shaft lever to the continuously variable transaxle assembly with the nut and washer.
Connect the park/neutral position switch connector.
33820B
2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.
Connect the transmission control cable assembly to the control shaft lever with the nut.
Before connecting the transmission control cable assembly, check that the park/neutral position switch and shift lever are in neutral.
74404A
3.INSTALL BATTERY CLAMP SUB-ASSEMBLY
89661
4.INSTALL ECM
17701
5.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17705
6.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
17751
7.INSTALL NO. 1 AIR CLEANER INLET
53141F
8.INSTALL RADIATOR COVER
28800
9.INSTALL BATTERY
10.CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
11.INSPECT SHIFT LEVER POSITION
12.ADJUST SHIFT LEVER POSITION
84540
13.INSPECT PARK/NEUTRAL POSITION SWITCH
84540
14.ADJUST PARK/NEUTRAL POSITION SWITCH
15. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART