Home › Drivetrain › EB62 MANUAL TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE › 2011.10–2013.07
RM19V0EQ _52 Drivetrain _014584 EB62 MANUAL TRANSMISSION / TRANSAXLE _0073999 TRANSMISSION CONTROL CABLE N

EB62 MANUAL TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  ADJUSTMENT  


PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17750A 2.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 17735 3.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17801 4.REMOVE AIR CLEANER FILTER ELEMENT

Hide 5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 58910C 6.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 58861B 7.REMOVE NO. 1 CONSOLE BOX DUCT

Hide 58995A 8.REMOVE NO. 1 CONSOLE BOX MOUNTING BRACKET

Hide 9.ADJUST TRANSMISSION CONTROL SELECT CABLE

a.
C248129
1.354,1.177 0.708,1.823 0.708,1.823 0.542,1.823 false 0.313,1.74 0.594,1.99 0.281,0.25 10 false *1
*1 Transmission Control Select Cable


Remove the clip and separate the transmission control select cable from the floor shift lever assembly.


b.
C248130C01
1.177,1.354 1.292,1.354 1.292,1.354 1.354,1.177 false 2.031,0.417 1.917,0.417 1.917,0.417 1.854,0.771 false 2.156,1.448 1.958,1.448 1.958,1.448 1.833,1.177 false 0.927,1.271 1.177,1.583 0.25,0.313 10 false *2 2.104,0.323 2.396,0.604 0.292,0.281 10 false *1 2.24,1.375 2.667,1.708 0.427,0.333 10 false *3 0.198,0.125 0.469,0.427 0.271,0.302 10 false *a 1.354,0.24 1.646,0.531 0.292,0.292 10 false *b 1.625,1.385 1.885,1.677 0.26,0.292 10 false *c 0.198,1.854 0.5,2.188 0.302,0.333 10 false *d
*1 Adjuster Case
*2 Lock Piece
*3 Slider
*a Before Lock Release
*b Push Out
*c Slide
*d After Lock Release


Release the lock of the cable length adjustment structure of the transmission control select cable.

i.

Slide the slider.


ii.

Push the lock piece downward to release the lock.



c.
C248131C01
2.094,0.125 1.917,0.125 1.917,0.125 1.656,0.792 false 0.573,1.313 0.781,1.313 0.781,1.313 1.469,0.917 false 2.167,0.052 2.458,0.302 0.292,0.25 10 true *1 0.354,1.25 0.646,1.531 0.292,0.281 10 false *2
*1 Outer Select Lever
*2 Hole


Align the hole of the outer select lever with the hole in the front transaxle case.


d.
C248132

Insert a bolt into the aligned holes to secure the outer select lever in place.

NOTICE:

Do not push in the bolt forcefully or damage the front transaxle case.


HINT:
·

Use a bolt with a diameter of 6 mm (0.236 in.) and a length of at least 16 mm (0.630 in.).

·

Depending on the bolt diameter, it may be difficult to insert the bolt. In that case, use a bolt with a diameter smaller than 6 mm (0.236 in.).




e.
C248133C01
0.51,1.708 0.667,1.708 false 1.042,1.135 0.906,1.135 0.906,1.135 0.844,1.354 false 1.073,1.063 1.385,1.344 0.313,0.281 10 false *1 0.333,1.646 0.615,1.885 0.281,0.24 10 false *2
*1 Slider Shaft
*2 Cam Wall


Push the slider shaft until it contacts the cam wall.

NOTICE:
·

Do not pull up the slider shaft.

·

When adjusting the cable, make sure that the shift lever is not in the 1st or 2nd gear position.




f.
C248158C01
0.365,1.5 0.365,1.729 false 1.958,0.927 1.865,0.927 1.865,0.927 1.802,1.042 false 1.99,0.865 2.333,1.094 0.344,0.229 10 false *1 0.292,1.781 0.583,2.052 0.292,0.271 10 false *2
*1 Transmission Control Select Cable
*2 Lock Piece


Install the transmission control select cable to the floor shift lever assembly with a new clip.

NOTICE:
·

Make sure that the lock piece protrudes from the adjuster case.

·

When adjusting the cable, make sure that the shift lever is not in the 1st or 2nd gear position.




g.

Press in the lock piece to the adjuster case.

NOTICE:

Securely press in the lock piece until the lock engages.



h.
C248132

Remove the bolt to release the select outer lever.


Hide 58995A 10.INSTALL NO. 1 CONSOLE BOX MOUNTING BRACKET

Hide 58861B 11.INSTALL NO. 1 CONSOLE BOX DUCT

Hide 58910C 12.INSTALL REAR CONSOLE BOX ASSEMBLY

Hide 13.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Hide 17801 14.INSTALL AIR CLEANER FILTER ELEMENT

Hide 17735 15.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 17750A 16.INSTALL INLET AIR CLEANER ASSEMBLY

Hide 12601B 17.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY