The following procedure is for the No. 1 parking brake cable assembly, No. 3 parking brake cable assembly and No. 4 parking brake cable assembly.
Use the same procedure for the No. 3 parking brake cable assembly and No. 2 parking brake cable assembly.
46201
1.REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY (for Automatic Transaxle LHD)
46201
2.REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY (for Automatic Transaxle RHD)
46201E
3.REMOVE PARKING BRAKE LEVER SUB-ASSEMBLY (for Manual Transaxle)
46410
4.REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY (for Automatic Transaxle LHD)
Pull up the parking brake pedal claw.
Do not damage the No. 1 parking brake cable assembly.
Remove the adjusting nut.
Remove the clip from the No. 1 parking brake cable assembly.
Remove the No. 1 parking brake cable assembly from the parking brake pedal assembly.
46410
5.REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY (for Automatic Transaxle RHD)
Pull up the parking brake pedal claw.
Do not damage the No. 1 parking brake cable assembly.
Remove the adjusting nut.
Remove the clip from the No. 1 parking brake cable assembly.
Remove the No. 1 parking brake cable assembly from the parking brake pedal assembly.
46410
6.REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY (for Manual Transaxle)
Pull up the parking brake lever claw.
Do not damage the No. 1 parking brake cable assembly.
Remove the adjusting nut.
Remove the No. 1 parking brake cable assembly from the parking brake lever sub-assembly.
67918A
7.REMOVE REAR DOOR SCUFF PLATE LH (for RHD)
62332A
8.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH (for RHD)
Disconnect the rear door opening trim weatherstrip LH.
73233
9.REMOVE LAP BELT OUTER ANCHOR COVER (for RHD)
Remove the lap belt outer anchor cover (for LH Side).
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>REMOVAL
73220
10.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH (for RHD)
62414A
11.REMOVE CENTER PILLAR LOWER GARNISH LH (for RHD)
67917A
12.REMOVE REAR DOOR SCUFF PLATE RH (for RHD)
13.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH (for RHD)
Use the same procedure as for the LH side.
73233
14.REMOVE LAP BELT OUTER ANCHOR COVER (for RHD)
Remove the lap belt outer anchor cover (for RH Side).
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>REMOVAL
15.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY RH (for RHD)
62413A
16.REMOVE CENTER PILLAR LOWER GARNISH RH (for RHD)
17.REMOVE FRONT SEAT ASSEMBLY LH (for RHD)
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL
18.REMOVE FRONT SEAT ASSEMBLY RH (for RHD)
Use the same procedure as for the LH side.
86183D
19.REMOVE AUDIO AMPLIFIER COVER (for RHD)
for 10 Speakers: Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEREO COMPONENT AMPLIFIER>REMOVAL
20.REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET (for RHD)
for 10 Speakers: Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEREO COMPONENT AMPLIFIER>REMOVAL
58521B
21.REMOVE FLOOR CARPET HOOK (for RHD)
57054B
22.REMOVE NO. 4 CROSS MEMBER FLOOR REINFORCEMENT SUB-ASSEMBLY (for RHD)
Remove the screw.
Disengage the guide to disconnect the fuel lid lock open lever sub-assembly as shown in the illustration.
Turn back the floor carpet to a position where the No. 4 cross member floor reinforcement sub-assembly can be removed.
Remove the 6 bolts and No. 4 cross member floor reinforcement sub-assembly.
46440
23.REMOVE NO. 4 PARKING BRAKE CABLE ASSEMBLY (for Automatic Transaxle)
| *1 | Parking Brake Equalizer |
| *2 | No. 2 Parking Brake Cable Assembly |
| *3 | No. 3 Parking Brake Cable Assembly |
| *4 | No. 4 Parking Brake Cable Assembly |
Separate the No. 3 parking brake cable assembly from the parking brake equalizer.
Separate the No. 2 parking brake cable assembly to remove the parking brake equalizer.
| *1 | Rubber Boot |
| *2 | Parking Brake Equalizer |
| *3 | No. 4 Parking Brake Cable Assembly |
Slide the parking brake equalizer and rubber boot.
Remove the No. 4 parking brake cable assembly from the parking brake equalizer.
17410
24.REMOVE FRONT EXHAUST PIPE ASSEMBLY
58154
25.REMOVE FRONT NO. 2 FLOOR HEAT INSULATOR
Remove the 3 nuts and front No. 2 floor heat insulator.
26.SEPARATE PARKING BRAKE SHOE LEVER
for ADVICS Made: Click hereBrake>PARKING BRAKE>PARKING BRAKE ASSEMBLY>DISASSEMBLY
46430
27.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
for PBR Made:
Remove the clip.
Turn and disconnect the No. 3 parking brake cable assembly.
46430
28.REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY
for PBR Made:
| *A | for Automatic Transaxle |
| *B | for Manual Transaxle |
Remove the clip from the No. 3 parking brake cable assembly.
Remove the 4 bolts, nut and No. 3 parking brake cable assembly.
for ADVICS Made:
| *A | for Automatic Transaxle |
| *B | for Manual Transaxle |
Remove the clip from the No. 3 parking brake cable assembly.
Remove the 2 bolts and separate the No. 3 parking brake cable assembly.
Remove the 4 bolts, nut and No. 3 parking brake cable assembly.
46420B
29.REMOVE NO. 2 PARKING BRAKE CABLE CLAMP
Remove the No. 2 parking brake cable clamp from the No. 3 parking brake cable assembly.