46420B
1.INSTALL NO. 2 PARKING BRAKE CABLE CLAMP
Install the No. 2 parking brake cable clamp to the No. 3 parking brake cable assembly.
46430
2.INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
for PBR Made:
Install the No. 3 parking brake cable assembly with the 4 bolts and nut.
Install the clip to the No. 3 parking brake cable assembly.
for ADVICS Made:
Install the No. 3 parking brake cable assembly with the 4 bolts and nut.
Install the No. 3 parking brake cable assembly with the 2 bolts.
Install the clip to the No. 3 parking brake cable assembly.
46430
3.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
for PBR Made:
Turn and connect the No. 3 parking brake cable assembly.
Using a brass bar and a hammer, install the clip to the No. 3 parking brake cable assembly.
4.CONNECT PARKING BRAKE SHOE LEVER
for ADVICS Made: Click hereBrake>PARKING BRAKE>PARKING BRAKE ASSEMBLY>REASSEMBLY
58154
5.INSTALL FRONT NO. 2 FLOOR HEAT INSULATOR
Install the front No. 2 floor heat insulator with the 3 nuts.
17410
6.INSTALL FRONT EXHAUST PIPE ASSEMBLY
46440
7.INSTALL NO. 4 PARKING BRAKE CABLE ASSEMBLY
| *1 | No. 4 Parking Brake Cable Assembly |
| *2 | Rubber Boot |
| *3 | Parking Brake Equalizer |
Install the No. 4 parking brake cable assembly to the parking brake equalizer.
Slide the parking brake equalizer and rubber boot as shown in the illustration.
Make sure that the rubber boot is securely inserted into the groove of the No. 4 parking brake cable assembly.
| *1 | Parking Brake Equalizer |
| *2 | No. 2 Parking Brake Cable Assembly |
| *3 | No. 3 Parking Brake Cable Assembly |
| *4 | No. 4 Parking Brake Cable Assembly |
Connect the No. 3 parking brake cable assembly to the parking brake equalizer.
Connect the No. 2 parking brake cable assembly to the parking brake equalizer.
57054B
8.INSTALL NO. 4 CROSS MEMBER FLOOR REINFORCEMENT SUB-ASSEMBLY (for RHD)
Install the No. 4 cross member floor reinforcement sub-assembly with the 6 bolts.
Install the floor carpet.
Engage the guide to connect the fuel lid lock open lever sub-assembly as shown in the illustration.
Install the screw.
58521B
9.INSTALL FLOOR CARPET HOOK (for RHD)
10.INSTALL STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET (for RHD)
for 10 Speakers: Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEREO COMPONENT AMPLIFIER>INSTALLATION
86183D
11.INSTALL AUDIO AMPLIFIER COVER (for RHD)
for 10 Speakers: Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEREO COMPONENT AMPLIFIER>INSTALLATION
12.INSTALL FRONT SEAT ASSEMBLY LH (for RHD)
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION
13.INSTALL FRONT SEAT ASSEMBLY RH (for RHD)
Use the same procedure as for the LH side.
62414A
14.INSTALL CENTER PILLAR LOWER GARNISH LH (for RHD)
73220
15.CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH (for RHD)
73233
16.INSTALL LAP BELT OUTER ANCHOR COVER (for RHD)
Remove the lap belt outer anchor cover (for LH Side).
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>INSTALLATION
62332A
17.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH (for RHD)
67918A
18.INSTALL REAR DOOR SCUFF PLATE LH (for RHD)
62413A
19.INSTALL CENTER PILLAR LOWER GARNISH RH (for RHD)
20.CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH (for RHD)
73233
21.INSTALL LAP BELT OUTER ANCHOR COVER (for RHD)
Remove the lap belt outer anchor cover (for RH Side).
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
22.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH (for RHD)
67917A
23.INSTALL REAR DOOR SCUFF PLATE RH (for RHD)
46410
24.INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY (for LHD)
Pass the No. 1 parking brake cable assembly through the parking brake pedal assembly.
Install the clip to the No. 1 parking brake cable assembly.
Temporarily install the adjusting nut.
Bend the parking brake pedal claw.
46410
25.INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY (for RHD)
Pass the No. 1 parking brake cable assembly through the parking brake pedal assembly.
Install the clip to the No. 1 parking brake cable assembly.
Temporarily install the adjusting nut.
Bend the parking brake pedal claw.
46201
26.INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY (for LHD)
46201
27.INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY (for RHD)