Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER › from 2015.04
RM19V0EQ _58 Vehicle Interior _014613 HEATING / AIR CONDITIONING _0074190 CONDENSER A

HEATING / AIR CONDITIONING  CONDENSER  INSTALLATION  


PROCEDURE

Hide 88460 1.INSTALL COOLER CONDENSER ASSEMBLY

a.
E312991

Engage the 2 guides as shown in the illustration.


b.

Install the cooler condenser assembly with the 4 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)

HINT:

If the condenser is replaced with a new one, add compressor oil to the new condenser.


Capacity:

40 cc (1.35 fl. oz)


Compressor Oil:

ND-8 or equivalent



Hide 88710E 2.CONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY

a.

Remove the vinyl tape from the tube and the connector part of the cooler condenser assembly.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.

Compressor Oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the air conditioner tube and accessory assembly.


d.

Install the air conditioner tube and accessory assembly to the cooler condenser assembly with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 88711 3.CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.

Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser assembly.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.

Compressor Oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the No. 1 cooler refrigerant discharge hose.


d.

Install the No. 1 cooler refrigerant discharge hose to the cooler condenser assembly with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 53294C 4.INSTALL RADIATOR SIDE DEFLECTOR LH

a.

Engage the guide and 3 claws to install the radiator side deflector LH.


Hide 53293C 5.INSTALL RADIATOR SIDE DEFLECTOR RH

a.

Engage the guide and 3 claws to install the radiator side deflector RH.


Hide 53216A 6.INSTALL UPPER RADIATOR SUPPORT

Hide 53510 7.INSTALL HOOD LOCK ASSEMBLY (for LHD)

Hide 53510 8.INSTALL HOOD LOCK ASSEMBLY (for RHD)

Hide 17750A 9.INSTALL INLET AIR CLEANER ASSEMBLY

Hide 10.INSTALL FRONT BUMPER ASSEMBLY

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 12.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT

Hide 53301 15.ADJUST HOOD SUB-ASSEMBLY