Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM2040EQ _52 Drivetrain _014703 AXLE AND DIFFERENTIAL _0074958 FRONT AXLE HUB G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal, Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55702A 3.REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 4. DISABLE BRAKE CONTROL

Hide 5.REMOVE FRONT WHEEL

Hide 6.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 43512 7.REMOVE FRONT DISC

Hide 8.INSPECT FRONT AXLE HUB BEARING LOOSENESS

a.
C238966

Using a dial indicator, check for looseness near the center of the front axle hub.

Maximum looseness:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the front speed sensor.



If the looseness exceeds the maximum, replace the front axle hub bearing.


Hide 9.INSPECT FRONT AXLE HUB RUNOUT

a.
C238967

Using a dial indicator, check for runout on the surface of the front axle hub outside the hub bolts.

Maximum runout:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the front speed sensor.



If the runout exceeds the maximum, replace the front axle hub.


Hide 43512 10.INSTALL FRONT DISC

Hide 11.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 12.INSTALL FRONT WHEEL

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)

Hide 13.CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

a.

Connect the cable to the negative (-) auxiliary battery terminal.

Click herePower Source / Network>2AR-FXE BATTERY / CHARGING>AUXILIARY BATTERY>INSTALLATION


b.

Connect the reservoir level switch connector.



Hide 55702A 14.INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 15.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY