Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM › from 2016.05
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074885 HYBRID CONTROL SYSTEM T

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


Hybrid Control System
Symptom Suspected Area Link
Cannot enter EV mode CAN communication system Click here
Combination meter assembly Click here
EV drive mode switch (pattern select switch assembly) Click here
Pattern select switch EV mode circuit Click here
EV mode indicator light does not illuminate Combination meter assembly Click here
EV drive mode switch (pattern select switch assembly) Click here
Pattern select switch EV mode circuit Click here
EV mode indicator light does not turn off Combination meter assembly Click here
EV drive mode switch (pattern select switch assembly) Click here
Pattern select switch EV mode circuit Click here
Cannot enter ECO mode CAN communication system Click here
Combination meter assembly Click here
ECO mode switch (eco switch assembly) Click here
Pattern select switch ECO mode circuit Click here
ECO mode indicator light does not illuminate Combination meter assembly Click here
ECO mode switch (eco switch assembly) Click here
Pattern select switch ECO mode circuit Click here
ECO mode indicator light does not turn off Combination meter assembly Click here
ECO mode switch (eco switch assembly) Click here
Pattern select switch ECO mode circuit Click here
Hesitation and/or poor acceleration Brake override system Click here
Loud rattle from hybrid vehicle transaxle Loud Rattle from Hybrid Vehicle Transmission Click here
Transmission input damper assembly Click here
Hybrid vehicle transaxle assembly Click here
Power switch does not turn on (READY). Battery smart unit (wrong assembly confirmation)* Click here
Smart entry and start system (for start function) Click here
ECU power source circuit Click here
Power management control ECU Click here
ECM Click here

1.

If the battery smart unit had been replaced just before the malfunction occurred, check the part number of the battery smart unit.

2.

Using the GTS, check the vehicle control history. Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>VEHICLE CONTROL HISTORY

HINT:

If "Battery Smart Unit Mismatch" is displayed, the wrong type of battery smart unit is installed.


3.

After installing the battery smart unit, perform the following to check that the power switch can be turned on (READY).

1.

Turn the power switch on (READY).

2.

Turn the power switch off and wait for 30 seconds or more.

3.

Turn the power switch on (READY) again.



HINT:
·

The type of battery smart unit to be used varies depending on the vehicle model.

·

If the wrong type of battery smart unit is installed, the power switch cannot be turned on (READY).