Home › Vehicle Interior › INTERIOR PANELS / TRIM › INSTRUMENT PANEL SAFETY PAD › from 2016.05
RM2040EQ _58 Vehicle Interior _014732 INTERIOR PANELS / TRIM _0075132 INSTRUMENT PANEL SAFETY PAD A

INTERIOR PANELS / TRIM  INSTRUMENT PANEL SAFETY PAD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67913 4.REMOVE FRONT DOOR SCUFF PLATE RH

Hide 62111A 5.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

Hide 62311B 6.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

a.
B401563

Disconnect the front door opening trim weatherstrip RH.


Hide 55317A 7.REMOVE INSTRUMENT SIDE PANEL RH

a.
B308715

Using a moulding remover, disengage the 4 claws as shown in the illustration.


b.
B401564

Disengage the 3 guides and remove the instrument side panel RH as shown in the illustration.


Hide 55431B 8.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL

a.
B401565

Disengage the 4 clips as shown in the illustration.


b.

Disconnect the connector to remove the upper instrument panel finish panel.


Hide 55670 9.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

a.
B308717C01
1.542,1.625 1.313,1.792 false 1.135,1.708 1.458,1.948 0.323,0.24 10 false *1
*1 Protective Tape


Apply protective tape to the area shown in the illustration.


b.
B308720

Disengage the 2 clips as shown in the illustration.


c.
B308721

Using a moulding remover, disengage the 2 clips to remove the No. 3 instrument panel register assembly.


Hide 55410C 10.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

a.

Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.


b.
B401566

Using a moulding remover, disengage the 2 claws, 4 clips and 2 guides.


c.
B308724

Disengage the 5 claws, 5 clips and 2 guides.


d.

Disconnect each connector.


e.
B308725

Remove the instrument cluster finish panel assembly as shown in the illustration.


Hide 83100 11.REMOVE COMBINATION METER ASSEMBLY

Hide 53921B 12.REMOVE FRONT PANEL GARNISH RH

a.
B401567

Disengage the claw, 5 clips and 6 guides to remove the front panel garnish RH.


Hide 53601 13.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.
B308727

Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.


Hide 14.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY

a.
B403713

Remove the 2 bolts <B>.


b.
B401568

Disengage the 4 claws, 9 clips and 3 guides to remove the lower No. 1 instrument panel finish panel assembly.


Hide 53922B 15.REMOVE FRONT PANEL GARNISH LH

a.
B401569

Disengage the claw, 5 clips and 6 guides to remove the front panel garnish LH.


Hide 33504F 16.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

a.
B401570

Turn the shift lever knob sub-assembly counterclockwise and remove the shift lever knob sub-assembly.


Hide 58805C 17.REMOVE REAR CONSOLE UPPER PANEL SUB-ASSEMBLY

a.

Open the upper console panel sub-assembly door.


b.

Move the shift lever to N.


c.
B401571

Disengage the 4 clips.


d.

Disconnect each connector and remove the rear console upper panel sub-assembly.


Hide 58801E 18.REMOVE UPPER CONSOLE BOX SUB-ASSEMBLY (w/o Wireless Charger)

Hide 861C0 19.REMOVE MOBILE WIRELESS CHARGER CRADLE ASSEMBLY (w/ Wireless Charger)

Hide 58864B 20.REMOVE NO. 4 CONSOLE BOX DUCT

Hide 58815A 21.REMOVE CONSOLE BOX CARPET

Hide 22.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 23.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

a.
B308733

Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.


b.
B308734

Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.


c.
B308735

Disengage the 3 claws and 2 clips as shown in the illustration.


d.
B279874

Disengage the clamp.


e.

Disconnect the connector to remove the center instrument cluster finish panel assembly.


Hide 55660 24.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

a.
B308736

Pull the No. 2 instrument panel register assembly as shown in the illustration to disengage the 6 clips and remove the No. 2 instrument panel register assembly.


Hide 58916 25.REMOVE BOX BOTTOM MAT

a.
B308737

Remove the box bottom mat.


Hide 58804A 26.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

a.
B308738

Remove the 2 screws <C> or <D>.


b.
B308739

Disengage the 4 clips and guide as shown in the illustration.


c.

Disconnect each connector to remove the upper console panel sub-assembly.


Hide 27.REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/o Navigation System)

Hide 28.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/ Navigation System)

Hide 55510F 29.REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

a.
B308740

Disengage the 8 clips as shown in the illustration.


b.

Disconnect the connector to remove the No. 1 speaker opening cover assembly.


Hide 86160J 30.REMOVE FRONT NO. 3 SPEAKER ASSEMBLY (for 10 Speakers)

Hide 67914 31.REMOVE FRONT DOOR SCUFF PLATE LH

HINT:

Use the same procedure as for the RH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 62112A 32.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

HINT:

Use the same procedure as for the RH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 62312B 33.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

a.
B308741

Disconnect the front door opening trim weatherstrip LH.


Hide 55318C 34.REMOVE INSTRUMENT SIDE PANEL LH

a.
B308742

Using a moulding remover, disengage the 4 claws as shown in the illustration.


b.
B308743

Disengage the 3 guides to remove the instrument side panel RH as shown in the illustration.


Hide 55607 35.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

a.
B308744

Disengage the 4 claws and 2 guides.


b.

Disconnect the connector and remove the No. 2 instrument panel under cover sub-assembly.


Hide 55303B 36.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

a.
B308745

Remove the bolt <B> and screw <C> or <D>.


b.

Open the lower instrument panel door.


c.
B308746

Remove the 3 screws <C> or <D>.


d.
B308747

Disengage the 2 clips and 4 guides and remove the lower instrument panel sub-assembly.


Hide 55475A 37.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

a.
B308749

Disengage the 5 clips to remove the No. 2 instrument cluster finish panel garnish as shown in the illustration.


Hide 55650 38.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

a.
B308751C01
2.313,1.469 2.781,1.344 false 2.823,1.208 3.198,1.458 0.375,0.25 10 false *1
*1 Protective Tape


Apply protective tape to the area shown in the illustration.


b.
B308752

Disengage the 2 clips as shown in the illustration.


c.
B308753

Using a moulding remover, disengage the 2 clips to remove the No. 1 instrument panel register assembly.


Hide 62211 39.REMOVE FRONT PILLAR GARNISH RH

Hide 55409F 40.REMOVE NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

a.
B279896C06
1.302,1.323 1.156,1.583 false 1.031,1.594 1.385,1.875 0.354,0.281 10 false *1
*1 Protective Tape


Apply protective tape to the area shown in the illustration.


b.
B279897

Using a moulding remover, disengage the 2 clips and 3 claws.


c.

Disengage the 2 guides to remove the No. 2 instrument panel speaker panel sub-assembly.


Hide 86160P 41.REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (for RH Side)

Hide 62212 42.REMOVE FRONT PILLAR GARNISH LH

HINT:

Use the same procedure as for the RH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 55408F 43.REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

a.
B280301C07
2.417,1.677 2.302,1.313 false 2.365,1.698 2.854,1.99 0.49,0.292 10 false *1
*1 Protective Tape


Apply protective tape to the area shown in the illustration.


b.
B280302

Using a moulding remover, disengage the 2 clips and 3 claws.


c.

Disengage the 2 guides to remove the No. 1 instrument panel speaker panel sub-assembly.


Hide 86160P 44.REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (for LH Side)

HINT:

Use the same procedure as for the RH side.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL


Hide 55480D 45.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

a.
B308754

Disengage the 4 clips and guide and remove the lower instrument panel finish panel assembly.


Hide 58816B 46.REMOVE CONSOLE BOX INSERT

a.
B308756

Remove the 2 screws <C> or <D>.


b.
B308757

Disengage the clip and 3 guides to remove the console box insert as shown in the illustration.


c.
B308755

Disengage the 2 claws to disconnect the room temperature sensor from the console box insert.


Hide 58817A 47.REMOVE FRONT NO. 2 CONSOLE BOX INSERT

a.
B308759

Remove the 2 screws <C> or <D>.


b.
B308760

Disengage the clip and 3 guides to remove the front No. 2 console box insert as shown in the illustration.


Hide 55011A 48.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

a.

Disengage the 10 clips to remove the No. 1 instrument panel garnish sub-assembly as shown in the illustration.

B308762


Hide 82142A 49.DISCONNECT NO. 2 INSTRUMENT PANEL WIRE

Hide 50.REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

a.

Disconnect each connector.

B308763


b.

Disengage each clamp.


c.

Remove the 2 passenger airbag bolts <A>.

B308764C01
0.604,1.115 1.01,1.094 false 1.667,4.354 1.719,4.583 false 4.302,5.021 4.25,4.333 4.25,4.333 3.594,4.719 false 4.75,3.708 4.948,3.74 false 6.906,2.958 6.927,3.219 false 6.219,2.542 6.792,2.375 false 5.24,0.896 4.979,0.958 false 4.99,3.635 5.385,3.948 0.396,0.313 10 false *2 6.833,2.26 7.156,2.552 0.323,0.292 10 false *3 4.281,4.188 5.042,4.615 0.76,0.427 10 false *1 1.677,4.604 2.042,4.948 0.365,0.344 10 false *2 6.854,3.24 7.146,3.5 0.292,0.26 10 false *2 4.792,0.875 5.25,1.177 0.458,0.302 10 false *4 1.042,0.99 1.5,1.26 0.458,0.271 10 false *4
*1 Passenger Airbag Bolt <A> *2 Bolt <B>
*3 Nut <E> *4 Clip



d.

Remove the 3 bolts <B> and nut <E>.


e.

Remove the 2 clips.


f.

Disengage the 5 guides and remove the instrument panel safety pad assembly as shown in the illustration.

B308765

NOTICE:
·

Do not damage the instrument panel safety pad assembly.

·

Do not allow the wire harnesses to interfere with the surrounding parts.