Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1581/26    Assist Map Number Un-Writing

for Preparation Click here


DESCRIPTION

This DTC will be stored if the power steering ECU assembly determines that the assist map is not written in the ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1581/26
Assist map not written in power steering ECU assembly
  1. CAN communication system
  2. Hybrid control system
  3. Electronically controlled brake system
  4. Main body ECU (multiplex network body ECU)
  5. Power steering ECU assembly

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly has been replaced, perform assist map writing (Click here).

1.PERFORM ASSIST MAP WRITING
  1. Perform assist map writing (Click here).

  1. Check for DTCs (Click here).

Result 
Result
Proceed to
DTC C1581/26 is output
A
DTC C1581/26 is not output
B

NOTICE:
DTC C1581/26 is cleared after the assist map is written.



B
END
A


2.CHECK CAN COMMUNICATION SYSTEM
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTCs is not output
    A
    DTCs is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


3.CHECK RELATED PART (POWER MANAGEMENT CONTROL ECU, MAIN BODY ECU AND SKID CONTROL ECU)
  1. Check if any of the parts listed below have been replaced with an incorrect part in the past.

    Related Part
    Power management control ECU
    Main body ECU (multiplex network body ECU)
    Brake booster with master cylinder assembly (skid control ECU)

    NOTICE:
    When removing a related part to check it, be sure to follow the appropriate procedures and precautions.
    1. Refer to the following procedures to remove the power management control ECU (Click here).
    2. Refer to the following procedures to remove the main body ECU (multiplex network body ECU) (Click here).
    3. Refer to the following procedures to remove the brake booster with master cylinder assembly (skid control ECU) (for LHD) (Click here).
    4. Refer to the following procedures to remove the brake booster with master cylinder assembly (skid control ECU) (for RHD) (Click here).

    HINT:
    1. DTC C1581/26 is stored when a part with an incorrect part number is installed for the related parts listed above.
    2. When DTC C1581/26 is output when parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.

Result 
Result
Result
Proceed to
Proceed to
All installed related parts have correct part number
A
Part with incorrect part number is installed
B


B
REPLACE RELATED PART WITH PART THAT HAS CORRECT PART NUMBER
A

REPLACE POWER STEERING ECU ASSEMBLY (Click here)