Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

HYBRID CONTROL SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here



Hybrid Control System 
Symptom
Suspected Area
See page
Cannot enter EV mode
CAN communication system
Click here
Combination meter assembly
Click here
EV drive mode switch (pattern select switch assembly)
Click here
Pattern select switch EV mode circuit
Click here
EV mode indicator light does not illuminate
Combination meter assembly
Click here
EV drive mode switch (pattern select switch assembly)
Click here
Pattern select switch EV mode circuit
Click here
EV mode indicator light does not turn off
Combination meter assembly
Click here
EV drive mode switch (pattern select switch assembly)
Click here
Pattern select switch EV mode circuit
Click here
Cannot enter ECO mode
CAN communication system
Click here
Combination meter assembly
Click here
ECO mode switch (eco switch assembly)
Click here
Pattern select switch ECO mode circuit
Click here
ECO mode indicator light does not illuminate
Combination meter assembly
Click here
ECO mode switch (eco switch assembly)
Click here
Pattern select switch ECO mode circuit
Click here
ECO mode indicator light does not turn off
Combination meter assembly
Click here
ECO mode switch (eco switch assembly)
Click here
Pattern select switch ECO mode circuit
Click here
Hesitation and/or poor acceleration
Brake override system
Click here
Loud rattle from hybrid vehicle transaxle
Loud Rattle from Hybrid Vehicle Transmission
Click here
Transmission input damper assembly
Click here
Hybrid vehicle transaxle assembly
Click here
Power switch does not turn on (READY).
Battery smart unit (wrong assembly confirmation)*
Click here
Smart entry and start system (for start function)
Click here
ECU power source circuit
Click here
Power management control ECU
Click here
ECM
Click here
*: Check the part number of the battery smart unit.
  1. If the battery smart unit had been replaced just before the malfunction occurred, check the part number of the battery smart unit.
  2. Using the GTS, check the vehicle control history. (Click here)

    HINT:
    If "Battery Smart Unit Mismatch" is displayed, the wrong type of battery smart unit is installed.

  3. After installing the battery smart unit, perform the following to check that the power switch can be turned on (READY).
    1. Turn the power switch on (READY).
    2. Turn the power switch off and wait for 30 seconds or more.
    3. Turn the power switch on (READY) again.