Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Troubleshooting of the theft deterrent system is based on the premise that the power door lock control system and the wireless door lock control system are operating normally. Accordingly, before troubleshooting the theft deterrent system, first make certain that the power door lock control system and the wireless door lock control system are operating normally.
  2. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  3. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Theft Deterrent System 
Symptom
Suspected Area
See page
Theft deterrent system cannot be set
Engine immobiliser system (w/ Smart Entry and Start System) "security indicator light does not blink"*1
Click here
Engine immobiliser system (w/o Smart Entry and Start System) "security indicator light does not blink"*2
Click here
Front door courtesy switch circuit
Click here
Rear door courtesy switch circuit
Click here
Front door lock with motor assembly
Click here
Rear door lock with motor assembly
Click here
Luggage compartment door lock assembly
Click here
Engine hood courtesy switch circuit
Click here
Security indicator light does not blink when theft deterrent system is set
Engine immobiliser system (w/ Smart Entry and Start System) "security indicator light does not blink"*1
Click here
Engine immobiliser system (w/o Smart Entry and Start System) "security indicator light does not blink"*2
Click here
Alarm sounding state cannot be canceled when ignition switch is turned to ON*1
Smart entry and start system (for start function)*3
Click here
Push-button Start*4
Click here
Certification ECU (smart key ECU assembly)
-
If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU)
Click here
Alarm sounding state cannot be canceled when ignition switch is turned to ON*2
Ignition switch circuit
Click here
Unlock warning switch circuit
Click here
If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU)
Click here
Theft deterrent system can be set even when door is open
Front door courtesy switch circuit
Click here
Rear door courtesy switch circuit
Click here
If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU)
Click here
Theft deterrent system can be set even when engine hood is open
Engine hood courtesy switch circuit
Click here
Vehicle horns do not sound while theft deterrent system is in warning operation
Horn circuit
Click here
Hazard warning lights do not flash while theft deterrent system is in warning operation
Combination meter assembly
-
If the symptom(s) still occur after the above areas are inspected and proved to be normal, replace the main body ECU (multiplex network body ECU)
Click here
Security horn does not sound while theft deterrent system is in warning operation
Security horn circuit
Click here
Hazard warning lights flash even when theft deterrent system is not set
Combination meter assembly
-
If the symptom(s) still occur after the above areas are inspected and proved to be normal, replace the main body ECU (multiplex network body ECU)
Click here
  1. *1: w/ Smart Entry and Start System
  2. *2: w/o Smart Entry and Start System
  3. *3: w/ Entry Function
  4. *4: w/o Entry Function