821H1
1.INSTALL HV FLOOR UNDER WIRE
Be sure to wear insulated gloves.
Insert the HV floor under wire into the floor panel hole and engage the grommet.
Install 2 new clamps in the order shown in the illustration.
Install the nut.
Install the 2 nuts and new clamp in the order shown in the illustration.
Install the nut.
Connect the HV floor under wire connector.
Engage the clamp.
Install the 2 nuts.
Install the HV floor under wire with the 2 nuts.
33820B
2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Connect the transmission control cable assembly to the vehicle body with the 2 nuts.
58223
3.INSTALL CENTER NO. 2 FLOOR HEAT INSULATOR
Install the center No. 2 floor heat insulator with the 3 nuts.
58398F
4.INSTALL NO. 1 FLOOR UNDER COVER (w/ Cover)
17141
5.INSTALL EXHAUST MANIFOLD
17410
6.INSTALL FRONT EXHAUST PIPE ASSEMBLY
821H1
7.CONNECT HV FLOOR UNDER WIRE
Be sure to wear insulated gloves.
Connect the floor wire connector.
Connect the shield ground to the HV battery.
Connect the 2 HV battery junction block assembly connectors.
Make sure that the connectors are connected securely.
G92N4A
8.INSTALL NO. 1 HV BATTERY COVER PANEL RH
71033
9.INSTALL REAR SEAT CUSHION LEG SUB-ASSEMBLY
76971G
10.INSTALL REAR UNDER COVER
76974F
11.INSTALL REAR UNDER SIDE COVER LH
67918A
12.INSTALL REAR DOOR SCUFF PLATE LH
76973F
13.INSTALL REAR UNDER SIDE COVER RH
67917A
14.INSTALL REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
72693
15.INSTALL REAR SEAT CUSHION LOCK HOOK
for Fold Down Seat Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Fold Down Seat Type)>INSTALLATION
for Reclining Seat Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Reclining Seat Type)>INSTALLATION
16.INSTALL REAR SEAT CUSHION ASSEMBLY
for Fold Down Seat Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Fold Down Seat Type)>INSTALLATION
for Reclining Seat Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Reclining Seat Type)>INSTALLATION
73350C
17.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
for Fold Down Seat Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Fold Down Seat Type)>INSTALLATION
for Reclining Seat Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Reclining Seat Type)>INSTALLATION
821H1
18.CONNECT HV FLOOR UNDER WIRE
82111
19.CONNECT ENGINE ROOM MAIN WIRE
Be sure to wear insulated gloves.
Do not allow any foreign matter or water to enter the inverter with converter assembly.
Connect the inverter with converter assembly connector and move the lock lever to lock them.
Do not touch the waterproof seal or terminals of the connectors.
To prevent damage due to static electricity, do not touch the terminals of the disconnected connectors.
Do not damage the terminals, connector housing or inverter with converter assembly when connecting the connectors.
G3834
20.INSTALL SERVICE PLUG GRIP