Home › Engine / Hybrid System › 2GR-FE IGNITION › IGNITION COIL AND SPARK PLUG › 2013.04–2016.05
RM24M0E _51 Engine / Hybrid System _059555 2GR-FE IGNITION _0291864 IGNITION COIL AND SPARK PLUG A

2GR-FE IGNITION  IGNITION COIL AND SPARK PLUG  INSTALLATION  


PROCEDURE

Hide 19100P 1.INSTALL SPARK PLUG

a.
A137604

Install the 6 spark plugs.

Torque:
18 N*m (183 kgf*cm, 13 ft.*lbf)


Hide 19500 2.INSTALL IGNITION COIL ASSEMBLY

a.
A134966E03
0.135,0.094 0.802,0.458 0.667,0.365 10 true LH Bank: 0.135,2.292 0.792,2.635 0.656,0.344 10 true RH Bank:

Install the 6 ignition coils with the 6 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Connect the 6 ignition coil connectors.


Hide 88710E 3.INSTALL AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY (for LHD)

a.

Remove the attached vinyl tape from the pipe.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the air conditioning tube and accessory assembly.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring on the air conditioning tube and accessory assembly.


d.

Connect the air conditioning tube and accessory assembly.

A394011E01
5.448,1.448 6.458,2.021 1.01,0.573 10 false Disconnect tube by hand

HINT:

After the connection, check that the claw of the piping clamp is engaged.



e.
A161852

Install the plate with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 17125 4.INSTALL NO. 1 SURGE TANK STAY

NOTICE:

Do NOT apply oil to the bolt listed below:

Tightening Parts
No. 1 surge tank stay and cylinder head cover


a.
A134967

Install the No. 1 surge tank stay with the bolt.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


b.
A162505

Install the bolt and clamp.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


Hide 17190 5.INSTALL INTAKE AIR SURGE TANK ASSEMBLY

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 51442 9.INSTALL NO. 2 ENGINE UNDER COVER

Hide 55712 10.INSTALL FRONT COWL TOP OUTSIDE PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

Hide 47202 11.INSTALL BRAKE MASTER CYLINDER RESERVOIR BRACKET

Hide 55781F 12.INSTALL COWL TOP VENTILATOR LOUVER

Hide 53866J 13.INSTALL FRONT FENDER TO COWL SIDE SEAL RH

Hide 53867H 14.INSTALL FRONT FENDER TO COWL SIDE SEAL LH

Hide 85291A 15.INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

Hide 85291B 16.INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

Hide 20. WARM UP ENGINE

Hide 22.INSPECT FOR REFRIGERANT LEAK (for LHD)

Hide 23. PERFORM INITIALIZATION