Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM › from 2016.05
RM24M0E _55 Steering _059560 STEERING COLUMN _0291889 STEERING LOCK SYSTEM T

STEERING COLUMN  STEERING LOCK SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:

Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Steering lock system
Symptom Suspected Area See page
Steering wheel cannot unlock (engine cannot start). 1. Smart entry and start system (for 2AZ-FE) (Click here)
2. Smart entry and start system (for 2GR-FE) (Click here)
3. Push-button start (for 2AZ-FE) (Click here)
4. Push-button start (for 2GR-FE) (Click here)
5. Main body ECU (Click here)
6. Certification ECU -
7. Steering lock motor drive power circuit (Click here)
8. Power source circuit (Click here)
9. Steering lock actuator (Steering lock ECU) (Click here)
10. Unlock position sensor signal circuit (Click here)
Steering wheel cannot unlock (after connecting intelligent tester to DLC3, starting engine, Data List certification ECUs item Lock/Unlock Receive data is read, and steering lock command reception records display is NO). 1. Smart entry and start system (for 2AZ-FE) (Click here)
2. Smart entry and start system (for 2GR-FE) (Click here)
3. Push-button start (for 2AZ-FE) (Click here)
4. Push-button start (for 2GR-FE) (Click here)
5. Main body ECU (Click here)
6. Certification ECU -
7. ID code box -
8. LIN communication line (Click here)
Steering wheel cannot lock. 1. Smart entry and start system (for 2AZ-FE) (Click here)
2. Smart entry and start system (for 2GR-FE) (Click here)
3. Push-button start (for 2AZ-FE) (Click here)
4. Push-button start (for 2GR-FE) (Click here)
5. Main body ECU (Click here)
6. Certification ECU -
7. Steering lock motor drive power circuit (Click here)
8. Power source circuit (Click here)
9. Steering lock actuator (Steering lock ECU) (Click here)
Steering wheel cannot lock (after connecting intelligent tester to DLC3, starting engine, Data List certification ECUs item Lock/Unlock Receive data is read, and steering lock command reception records display is NO). 1. Smart entry and start system (for 2AZ-FE) (Click here)
2. Smart entry and start system (for 2GR-FE) (Click here)
3. Push-button start (for 2AZ-FE) (Click here)
4. Push-button start (for 2GR-FE) (Click here)
5. Main body ECU (Click here)
6. Certification ECU -
7. ID code box -
8. LIN communication line (Click here)