1. CHECK STEERING EFFORT (TORQUE)
Some service operations affect the SRS airbags. Be sure to read the precautionary notice for the SRS airbags before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Stop the vehicle on a level, paved surface and align the wheels straight ahead.
Disconnect the negative (-) battery cable from the battery (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD>REMOVAL).
Remove the steering pad (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD>REMOVAL).
Connect the negative (-) battery cable to the battery.
Using a torque wrench, check if the steering wheel set nut is properly tightened.
Start the engine so that the power steering is ready to operate.
Turn the steering wheel 90° to the right and check the steering effort (torque) while turning. Check in the opposite direction using the same method.
6.9 N*m (70 kgf*cm, 61 in.*lbf) or less
Align the front wheels straight ahead.
Turn the engine switch off.
Disconnect the negative (-) battery cable from the battery.
Install the steering pad (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD>INSTALLATION).
Connect the negative (-) battery cable to the battery.
Clear the DTCs (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Inspect the airbag warning light (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).