Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › DRIVER SIDE KNEE AIRBAG ASSEMBLY › from 2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291901 DRIVER SIDE KNEE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  DRIVER SIDE KNEE AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 73900 1.INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

a.
C136825

Connect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Install the knee airbag with the 4 bolts.

Torque:
10 N*m (101 kgf*cm, 7 ft.*lbf)


Hide 55432B 2.INSTALL INSTRUMENT PANEL FINISH PANEL LOWER

Hide 55606 3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 62112 4.INSTALL COWL SIDE TRIM BOARD LH (for LHD)

Hide 67914B 5.INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)

Hide 55446A 6.INSTALL NO. 1 SWITCH HOLE BASE (for LHD)

Hide 55041B 7.INSTALL NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY (for LHD)

Hide 55650 8.INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)

Hide 55411G 9.INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY (for LHD)

Hide 62111C 10.INSTALL COWL SIDE TRIM BOARD RH (for RHD)

HINT:

Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR>ROOF HEADLINING>INSTALLATION).


Hide 67913B 11.INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)

HINT:

Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR>ROOF HEADLINING>INSTALLATION).


Hide 55446A 12.INSTALL NO. 1 SWITCH HOLE BASE (for RHD)

Hide 55041B 13.INSTALL NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY (for RHD)

Hide 14.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for RHD)

Hide 33504F 15.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for RHD)

Hide 28800 16.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 17.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



Hide 18.CHECK SRS WARNING LIGHT