The ECM determines the vehicle inclination based on a signal from the yaw rate sensor or deceleration sensor.
If a CAN communication DTC is output, perform troubleshooting for that DTC first.
| DTC No. | DTC Detection Condition
1.
Diagnosis Condition 2.
Malfunction Status 3.
Malfunction Time 4.
Other |
Trouble Area |
|---|---|---|
| P1586 | 1.
The engine switch is on (IG). 2.
With a vehicle speed of 30 km/h (18 mph) or more, the difference between the longitudinal acceleration calculated based on the G sensor value and the longitudinal acceleration calculated based on the vehicle speed exceeds 0.35 G for 60 seconds or more. 3.
3.0 seconds 4.
1 trip detection logic |
·
Deceleration sensor*1 ·
Yaw rate sensor*2 ·
Brake actuator assembly (Skid control ECU) ·
CAN communication system |
1.
The engine switch is on (IG). 2.
No change detected in the G sensor signal 16 times or more while the vehicle speed decreases from 30 km/h (18 mph) to 0 km/h (0 mph). 3.
3.0 seconds 4.
1 trip detection logic |
*1: w/o VSC
*2: w/ VSC
Refer to DTC P1585 (See page Drivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>P1585).
A
B
Clear the DTCs (See page Drivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR).
Perform a road test where the vehicle is driven at 30 km/h (18 mph) or more, the brakes are applied at least 16 times and the vehicle is finally stopped.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs using the tester.
| Result | Proceed to |
|---|---|
| Only P1586 is output | A |
| P1586 and other DTCs are output | B |
If any other DTCs besides DTC P1586 are output, perform troubleshooting for those DTCs first.
A
B
(See pageDrivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)
A
B
C
D
(See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR(for 2AZ-FE without VSC)>REMOVAL)
NEXT
NEXT
NEXT
NEXT
NEXT
NEXT