42440
1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
Install the axle hub and bearing to the axle carrier with the 4 bolts.
Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.
89516
2.INSTALL SKID CONTROL SENSOR WIRE
42431
3.INSTALL REAR DISC
47750A
4.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
Install the caliper with 2 bolts.
5.INSTALL REAR WHEEL
T = 103 N*m{ 1,050 kgf*cm 76 ft.*lbf }
6.INSPECT REAR WHEEL ALIGNMENT
Inspect the rear wheel alignment (see page Suspension>SUSPENSION>REAR WHEEL ALIGNMENT>ADJUSTMENT).
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See Page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
8.CHECK SPEED SENSOR SIGNAL
Check the speed sensor signal for ABS (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE).
Check the speed sensor signal for VSC (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TEST MODE PROCEDURE).