Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
43340A
1.INSTALL FRONT LOWER BALL JOINT ASSEMBLY LH
Install the lower ball joint with the nut to the steering knuckle.
Install a new clip.
If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
2.INSTALL STEERING KNUCKLE WITH AXLE HUB
48069
3.CONNECT FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY LH
45046
4.CONNECT TIE ROD END SUB-ASSEMBLY LH
43512
5.INSTALL FRONT DISC (for 16 inch Front Disc Brake)
43512
6.INSTALL FRONT DISC (for 17 inch Front Disc Brake)
7.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH
43502H
8.INSTALL FRONT AXLE HUB NUT (for 2AZ-FE)
43502H
9.INSTALL FRONT AXLE HUB NUT (for 2GR-FE)
89543
10.INSTALL FRONT SPEED SENSOR LH
11.INSTALL FRONT WHEEL
12.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Inspect and adjust the front wheel alignment (See page Suspension>SUSPENSION>FRONT WHEEL ALIGNMENT>ADJUSTMENT).
13.CHECK SPEED SENSOR SIGNAL