Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


If there are no DTCs output but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.

NOTICE:
When replacing the brake actuator assembly, sensor, etc., turn the ignition switch off.

HINT:
Inspect the fuse and relay before investigating the suspected areas as shown in the table below. Inspect each malfunction circuit in numerical order for the corresponding symptom.


Anti-lock brake system: 
Symptom
Suspected area
See page
ABS does not operate
1. Check the DTC again and make sure that the normal system code is output.
Click here
2. IG power source circuit
Click here
3. Front speed sensor circuit
Click here
4. Rear speed sensor circuit
Click here
5. Check the brake actuator with the intelligent tester. If abnormal, check the hydraulic circuit for leakage.
-
6. Front skid control rotor
Click here
7. Rear skid control rotor
Click here
8. If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly.
Click here
ABS does not operate efficiently
1. Check the DTC again and make sure that the normal system code is output.
Click here
2. Front speed sensor circuit
Click here
3. Rear speed sensor circuit
Click here
4. Stop light switch circuit
Click here
5. Check the brake actuator with intelligent tester. If abnormal, check that hydraulic circuit for leakage.
-
6. Front skid control rotor
Click here
7. Rear skid control rotor
Click here
8. If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to normal, replace the brake actuator assembly.
Click here
ABS warning light abnormal (Remains on)
1. ABS warning light circuit
Click here
2. Brake actuator assembly
Click here
ABS warning light abnormal (Does not come on)
1. ABS warning light circuit
Click here
2. Brake actuator assembly
Click here
ABS sensor DTC check cannot be done
1. Check the DTC again and make sure that the normal system code is output.
Click here
2. TC and CG terminal circuit
Click here
3. If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to normal, replace the brake actuator assembly.
Click here
Test mode (Signal check) cannot be done
1. TS and CG terminal circuit
Click here
2. Brake actuator assembly
Click here