2014-2019 Hiace · Service Manual BRAKE

C1413 Front Speed Sensor RH Output Malfunction

Diagnostic trouble codes · Vehicles built from Dec 2017

Also covers:

Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

Refer to DTCs C1401 and C1402 (Click here).
DTC No.
DTC Detection Condition
Trouble Area
C1413
C1414
Either of the following is detected:
  1. An open in the sensor signal circuit of a malfunctioning area occurs 255 times or more.
  2. At a vehicle speed of 20 km/h (12 mph) or more, noise occurs in the sensor signals of a malfunctioning wheel 75 times or more within 5 seconds.
  3. At a vehicle speed of 10 km/h (6 mph) or more, noise occurs once per rotor rotation for 15 seconds or more.
  1. Front speed sensor RH/LH
  2. Front skid control rotor RH/LH
  3. Sensor installation
  4. Wire harness or connector
  5. Skid control ECU (Brake actuator assembly)

HINT:
  1. DTC C1413 is for the front speed sensor RH.
  2. DTC C1414 is for the front speed sensor LH.


WIRING DIAGRAM

Refer to DTCs C1401 and C1402 (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).


1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION)


NG
Go to step 4
OK


2. READ VALUE USING GTS (FRONT SPEED SENSOR)


NG
Go to step 4
OK


3. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Start the engine.

  1. Perform a road test.

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTCs C1413 and C1414 are not output
    A
    DTCs C1413 and/or C1414 are output
    B



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)

4. CHECK FRONT SPEED SENSOR INSTALLATION


NG
INSTALL FRONT SPEED SENSOR CORRECTLY (Click here)
OK


5. INSPECT FRONT SPEED SENSOR TIP


NG
CLEAN OR REPLACE FRONT SPEED SENSOR
OK


6. INSPECT FRONT SPEED SENSOR ROTOR


NG
CLEAN OR REPLACE FRONT SKID CONTROL ROTOR
OK


7. CHECK HARNESS AND CONNECTOR (BRAKE ACTUATOR ASSEMBLY - FRONT SPEED SENSOR)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


8. INSPECT BRAKE ACTUATOR ASSEMBLY (SENSOR OUTPUT)


NG
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
OK

REPLACE FRONT SPEED SENSOR (Click here)


← C1413 Front Speed Sensor RH Output Malfunction (+ C1414) (Jan 2017 – Nov 2017)C1415 Rear Speed Sensor RH Output Malfunction (+ C1416) (Jan 2015 – Mar 2016) →