When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.
| Replaced Parts (A) | Pipes Requiring New Replacement |
|---|---|
| Injector assembly (including shuffling the injector assemblies between the cylinders) | ·
No. 1 injection pipe sub-assembly ·
No. 2 injection pipe sub-assembly |
| Supply pump assembly | Fuel inlet pipe sub-assembly |
·
Common rail assembly ·
Cylinder block sub-assembly ·
Cylinder head sub-assembly ·
Timing chain case assembly |
·
No. 1 injection pipe sub-assembly ·
No. 2 injection pipe sub-assembly ·
Fuel inlet pipe sub-assembly |
After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly, clean them with a brush and compressed air.
The common rail assembly is a precision instrument. Do not use the common rail assembly if it is struck or dropped.
Hold the common rail assembly itself during removal and installation. Do not hold the pressure discharge valve or fuel pressure sensor, etc.
Make sure foreign matter does not enter the fuel path.
23810A
1.INSTALL COMMON RAIL ASSEMBLY
Install the common rail assembly with the 2 nuts.
Connect the fuel pressure sensor connector to the common rail assembly.
Attach the wire harness clamp.
23282H
2.INSTALL NO. 4 FUEL HOSE
Connect the No. 4 fuel hose to the common rail assembly, and slide the clamp to secure the hose.
3.INSTALL WIRING HARNESS CLAMP BRACKET
4.TEMPORARILY INSTALL NO. 1 AND NO. 2 INJECTION PIPE SUB-ASSEMBLY
5.TIGHTEN NO. 1 AND NO. 2 INJECTION PIPE SUB-ASSEMBLY
23804C
6.INSTALL FUEL INLET PIPE SUB-ASSEMBLY
23815D
7.INSTALL NO. 3 FUEL PIPE (w/ Pressurized Fuel Filter)
23804D
8.INSTALL NO. 4 FUEL PIPE SUB-ASSEMBLY (w/ DPF)
17118
9.INSTALL MANIFOLD STAY
25624
10.INSTALL EGR VALVE ADAPTER (w/o EGR Cooler)
25800
11.INSTALL ELECTRIC EGR CONTROL VALVE ASSEMBLY (w/o EGR Cooler)
25800
12.INSTALL EGR COOLER SUB-ASSEMBLY AND NO. 2 EGR VALVE ASSEMBLY WITH ELECTRIC EGR CONTROL VALVE ASSEMBLY
13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
14. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
15.BLEED AIR FROM FUEL SYSTEM
16.INSPECT FOR FUEL LEAK