77378A
1.INSTALL FUEL FILLER OPENING LID LOCK COVER
Attach the clip and install the fuel filler opening lid lock cover.
77037
2.INSTALL FUEL FILLER OPENING LID LOCK SUB-ASSEMBLY
Install the fuel filler opening lid lock sub-assembly with the nut.
77035
3.INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
Attach the clamp and install the fuel lid lock control cable sub-assembly to the fuel filler opening lid lock sub-assembly.
77293A
4.INSTALL NO. 3 FUEL TANK FILLER PIPE SHIELD
Attach the claw and install the 7 grommets.
|
Install in this Direction |
Insert the fuel lid lock control cable sub-assembly into the vehicle from the service hole on the vehicle side as shown in the illustration.
While pulling out the fuel tank filler pipe shield assembly, install the No. 3 fuel tank filler pipe shield as shown in the illustration.
| *a | Protrusion | *b | Rib |
Align the protrusion of the fuel tank filler pipe shield assembly with the body rib and install the fuel tank filler pipe shield assembly as shown in the illustration.
w/ Urea SCR System:
Use the same procedure to install the fuel tank filler pipe shield assembly.
Install the fuel inlet box ring to the fuel tank filler pipe shield assembly as shown in the illustration.
| *1 | Fuel Inlet Box Ring | - | - |
Put the cut in the fuel inlet box ring downward.
w/ Urea SCR System:
Use the same procedure to install the fuel inlet box ring.
Using a 4 mm hexagon socket wrench, install the No. 3 fuel tank filler pipe shield with the 7 screws.
Remove the protective tape.
77310A
5.INSTALL FUEL TANK CAP ASSEMBLY
Attach the clamp and install the fuel tank cap assembly.
|
Install in this Direction |
Install the fuel tank cap assembly as shown in the illustration.
w/ Urea SCR System:
Use the same procedure to install the fuel inlet box ring.
77035
6.CONNECT FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
Attach the clamp and connect the fuel lid lock control cable sub-assembly.
|
Install in this Direction |
Install the front floor mat assembly as shown in the illustration.
77306
7.INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
Attach the clamp and install the fuel lid lock open lever sub-assembly to the fuel lid lock control cable sub-assembly.
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Attach the claw and guide to install the fuel lid lock open lever sub-assembly in the direction indicated by the arrow as shown in the illustration.
55641
8.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER
73220
9.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
for Semi-trim:
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY (for Semi-trim)>INSTALLATION
for Full-trim:
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY (for Full-trim)>INSTALLATION
10.INSTALL FRONT CONSOLE BOX (w/ Console Box)
62111C
11.INSTALL COWL SIDE TRIM BOARD RH
67913B
12.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>INSTALLATION
67911B
13.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>INSTALLATION
14.INSTALL FRONT SEAT ASSEMBLY RH
Use the same procedure for the RH and LH sides.
for Separate Seat Type:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Separate Seat Type)>INSTALLATION
for Fixed Bench Seat Type:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Fixed Bench Seat Type)>INSTALLATION
for Sliding Bench Seat Type:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Sliding Bench Seat Type)>INSTALLATION
15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)
for 7GR-FKS:
for 1GD-FTV:
16. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL (w/ Front Seat Side Airbag)
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is usel.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
17. CHECK SRS WARNING LIGHT (w/ Front Seat Side Airbag)
18. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Front Seat Side Airbag)
19.INSPECT SEAT BELT WARNING SYSTEM (w/ Seat Belt Warning System)