Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer and confirm the problem (Click here).


    NEXT


    3.CHECK DTC AND FREEZE FRAME DATA*
    1. Check and record DTCs and Freeze Frame Data.

    2. Clear the DTCs and Freeze Frame Data (Click here for DTC Check/Clear, or Click here for Freeze Frame Data).

    3. Reconfirm the DTCs.

      1. Reconfirm the DTCs based on the recorded DTCs and Freeze Frame Data (Click here for DTC Check/Clear, or Click here for Freeze Frame Data).

        HINT:
        1. When DTCs indicating CAN communication system malfunctions are output, repair the CAN communication system before repairing each corresponding sensor (Click here).
        2. If any of DTCs U0100, U0123, U0124, and U0126 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit (Click here).


        Result:

        Result
        Proceed to
        DTC is output
        A
        DTC is not output (Problem symptom does not occur)
        B
        DTC is not output (Problem symptom occurs)
        C



    B.
    GO TO STEP 5

    C.
    GO TO STEP 6
    A


    4.DIAGNOSTIC TROUBLE CODE CHART
    1. Proceed to Diagnostic Trouble Code Chart (Click here).


    NEXT

    GO TO STEP 7


    5.SYMPTOM SIMULATION
    1. Proceed to Diagnosis System (Click here).


    NEXT


    6.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table (Click here).


    NEXT


    7.CIRCUIT INSPECTION*

      NEXT


      8.IDENTIFICATION OF PROBLEM

        NEXT


        9.REPAIR OR REPLACEMENT

          NEXT


          10.CONFIRMATION TEST*

            NEXT

            END