DTC C0273 Open in ABS Motor Relay Circuit |
DTC C0274 Short in ABS Motor Relay Circuit |
DTC C1361 Short in ABS Motor Fail Safe Relay Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| C0273 | Either of the following is detected:
|
|
| C0274 | When the motor relay is OFF, the motor relay remains closed for 4 seconds or more. |
|
| C1361 | Immediately after the ignition switch is turned on (IG), the relay contact is closed for 4 seconds when the motor fail safe relay is OFF. |
|

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (ABS MOTOR RELAY) |
Connect Techstream to the DLC3.
Start the engine.
Select the Active Test mode on Techstream (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Motor Relay | ABS motor relay | Relay ON / OFF | Operating sound of motor can be heard |
Check for operating sound of the ABS motor relay when operating it with Techstream.
| Result | Proceed to |
| Operating sound is not heard | A |
| Operating sound is heard | B |
|
| ||||
| A | |
| 2.INSPECT VSC NO. 1 FUSE |
![]() |
Turn the ignition switch off.
Remove the fusible link block from the engine room relay block.
Check if the fusible link is melted.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| VSC NO. 1 (50 A) fuse - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT SKID CONTROL ECU (+BM TERMINAL) |
![]() |
Install the fusible link block to the engine room relay block with the nut.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A24-24 (+BM) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 4.INSPECT SKID CONTROL ECU (GND2 TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A24-13 (GND2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.RECONFIRM DTC |
Turn the ignition switch off.
Reconnect the skid control ECU connector.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTCs (C0273, C0274 and C1361) are not output | A |
| DTCs (C0273, C0274 and/or C1361) are output | B |
|
| ||||
| A | ||
| ||