DTC C1440 Steering Angle Sensor Unusual Bank Angle Detected |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1440 | The skid control ECU detects that the vehicle is driving on a bank at an angle of 30 degrees or more. | Yaw rate and acceleration sensor |
| 1.CHECK DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch on (IG) again and check that no CAN communication system DTC is output (Click here).
Drive the vehicle at a speed of 30 km/h (19 mph) or more, turn the steering wheel, and decelerate the vehicle (depress the brake pedal) and check that no yaw rate and acceleration sensor DTCs are output (Click here).
| Result | Proceed to |
| DTC (C1440) is output | A |
| CAN communication system DTC is output | B |
| Yaw rate and acceleration sensor DTC is output | C |
| DTC (C1440) is not output | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate and acceleration sensor has been installed properly (Click here).
|
| ||||
| OK | ||
| ||