Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > Brake Control Warning Light Remains ON

for Preparation Click here


DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.
If the skid control ECU stores a DTC, the brake warning light / yellow (minor malfunction) comes on in the combination meter.

HINT:
The master caution indicator light will come on and a brake malfunction message will be displayed on the multi-information display if the electronically controlled brake system control cannot be performed.


WIRING DIAGRAM


C174073E03


INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization and calibration of the linear solenoid valve (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED
  1. Check if the skid control ECU connector is securely connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR TO ECU CORRECTLY
OK


3.CHECK AUXILIARY BATTERY
  1. Check the auxiliary battery voltage.

    Standard voltage:
    11 to 14 V



NG
CHARGE OR REPLACE AUXILIARY BATTERY
OK


4.INSPECT COMBINATION METER ASSEMBLY
  1. Perform the Active Test of the combination meter (meter CPU) using the Techstream (Click here).

  1. Check the combination meter.

    OK:
    The brake warning light / yellow (minor malfunction) turns on or off in accordance with the Techstream operation.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table refer back to the table and proceed to the next step before replacing the part (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE SKID CONTROL ECU (Click here)