Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > Brake Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to Brake Warning Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization and calibration of the linear solenoid valve (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK BRAKE WARNING LIGHT / RED (MALFUNCTION)
  1. Disconnect the skid control ECU connectors.

  1. Turn the power switch on (IG).

  1. Check that the brake warning light / red (malfunction) comes on.

    OK:
    The brake warning light / red (malfunction) comes on.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).



NG
Go to step 3
OK

REPLACE SKID CONTROL ECU (Click here)  

3.INSPECT COMBINATION METER ASSEMBLY
  1. Turn the power switch off.

  1. Reconnect the skid control ECU connectors.

  1. Perform the Active Test of the combination meter (meter CPU) using the Techstream (Click here).

  1. Check the combination meter.

    OK:
    The brake warning light / red (malfunction) turns on or off in accordance with the Techstream operation.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE SKID CONTROL ECU (Click here)