1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. DISCHARGE FUEL SYSTEM PRESSURE
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
55701J
5.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)
55701J
6.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
22030
7.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
17190
8.REMOVE INTAKE AIR SURGE TANK ASSEMBLY
| *A | for LHD |
| *B | for RHD |
Slide the clip and disconnect the union to check valve hose from the intake air surge tank assembly.
Disconnect the union to check valve hose from the hose clamp.
Disconnect the fuel vapor feed hose from the intake air surge tank assembly.
Disconnect the fuel vapor feed hose from the hose clamp.
Slide the clip and disconnect the ventilation hose from the intake air surge tank assembly.
Disconnect the intake air control valve (for ACIS) connector.
Remove the bolt and separate the throttle body bracket from the intake air surge tank assembly.
Remove the bolt and separate the No. 1 surge tank stay from the intake air surge tank assembly.
|
Bolt |
|
Nut |
Remove the 2 nuts from the intake air surge tank assembly.
Using a 5 mm hexagon socket wrench, remove the 4 bolts and intake air surge tank assembly from the intake manifold.
Remove the 3 intake air surge tank gaskets from the intake manifold.
12327A
9.REMOVE NO. 2 ENGINE MOUNTING STAY RH (for Engine Mounting stay Side)
12327A
10.REMOVE NO. 2 ENGINE MOUNTING STAY RH (for Intake Manifold Side)
Remove the bolt and No. 2 engine mounting stay RH from the intake manifold.
23292D
11.REMOVE FUEL HOSE PROTECTOR
23901
12.DISCONNECT FUEL TUBE SUB-ASSEMBLY
23807
13.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
17111
14.REMOVE INTAKE MANIFOLD
|
Bolt |
|
Nut |
Remove the 6 bolts, 4 nuts and intake manifold from the cylinder head sub-assembly.
Remove the intake manifold to head gasket from each cylinder head sub-assembly.
15.REMOVE STUD BOLT
If a stud bolt is deformed or the threads are damaged, replace it.
Using an E8 "TORX" socket wrench, remove the 2 stud bolts from the intake manifold.