The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 2 fuel pressure sensor removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
To prevent serious injury due to fuel spray from the high-pressure fuel lines, always discharge fuel system pressure before removing any fuel system components.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
2. DISCHARGE FUEL SYSTEM PRESSURE
58441L
3.REMOVE BATTERY SERVICE HOLE COVER
4.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
22030
5.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
25620
6.REMOVE EGR VALVE ASSEMBLY
16278
7.REMOVE NO. 2 WATER BY-PASS PIPE
23910A
8.DISCONNECT FUEL TUBE SUB-ASSEMBLY
23801P
9.REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY
23100X
10.REMOVE FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY
89458H
11.REMOVE NO. 2 FUEL PRESSURE SENSOR
Disconnect the No. 2 fuel pressure sensor connector.
Using an 8 mm socket wrench, remove the bolt, No. 2 fuel pressure sensor and No. 2 fuel pressure sensor holder from the fuel delivery pipe sub-assembly.
Remove the O-ring from the No. 2 fuel pressure sensor.