Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM › 2020.02–2020.11
RM37A0E _59 Vehicle Exterior _086885 DOOR / HATCH _0418593 POWER BACK DOOR SYSTEM T

DOOR / HATCH  POWER BACK DOOR SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

If the multiplex network door ECU has been removed and installed or replaced, or if any of the connectors have been disconnected, initialize the power back door system.

Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>INITIALIZATION

·

The auxiliary battery supplies power to the main body ECU (multiplex network body ECU) via the door control battery. Therefore, before performing troubleshooting, make sure to perform an on-vehicle inspection to confirm that the main body ECU (multiplex network body ECU) power source circuit is normal.*

Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>ON-VEHICLE INSPECTION

*: w/ Door Control Battery




HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Power Back Door System
Symptom Suspected Area Link
Power back door cannot be operated using any switch Meter / gauge system Click here
Power back door sensor assembly LH
Power back door sensor assembly RH
Wire harness and connector
Multiplex network door ECU
Power back door does not operate using the cabin switch Power back door control switch Click here
Wire harness and connector
Multiplex network door ECU
Main body ECU (multiplex network body ECU)
Power back door does not operate using the outside switch No. 1 power back door control switch Click here
Wire harness and connector
Multiplex network door ECU
Power back door cannot be opened using the back door opener switch assembly (open switch) (back door entry unlock function is normally) Multiplex network door ECU Click here
Back door closer does not operate Back door visual check (foreign objects) Click here
Back door lock with courtesy light switch assembly
Wire harness and connector
Multiplex network door ECU
The back door closer does not reverse rotation operation properly when the back door opener switch assembly (open switch) is operated (during the back door closer operation). Entry and Start system (for Entry Function) Click here
Multiplex network door ECU Click here
Power back door warning system does not operate Wireless door lock control system Click here
Wire harness and connector
Power back door warning buzzer
Multiplex network door ECU
Main body ECU (multiplex network body ECU)
Jam protection function activates during power back door operation Back door visual check (foreign objects) Click here
Power back door unit assembly set LH
Power back door unit assembly set RH
Power back door sensor assembly LH
Power back door sensor assembly RH
Wire harness and connector
Multiplex network door ECU