Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY (for A25A-FXS, A25B-FXS)
RM37A0E _52 Drivetrain _086862 DRIVE SHAFT / PROPELLER SHAFT _0421214 REAR DRIVE SHAFT ASSEMBLY(for A25A-FXS, A25B-FXS) A

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY(for A25A-FXS, A25B-FXS)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 42341C 1.INSTALL REAR DRIVE SHAFT SNAP RING

a.

Install a new rear drive shaft snap ring.

NOTICE:

Face the end gap of the rear drive shaft snap ring downward.



Hide 42340B 2.INSTALL REAR DRIVE SHAFT ASSEMBLY

a.

Coat the rear drive shaft snap ring of the rear drive shaft inboard joint assembly with MP grease.


b.

Coat the splines of the rear drive shaft inboard joint assembly with Toyota genuine ATF WS.


c.
C338308

Align the inboard joint splines, and using a brass bar and a hammer, install the rear drive shaft assembly.

NOTICE:
·

Face the end gap of the rear drive shaft snap ring downward.

·

Do not damage the rear drive shaft oil seal.

·

Do not damage the rear drive shaft inboard joint boot.

·

Make sure to center the rear drive shaft assembly during installation to prevent damage to the rear drive shaft snap ring.



HINT:

Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.



d.
C338275C02
2.781,0.958 2.01,1.729 2.01,1.729 2.948,1.292 true 1.854,1.656 2.167,1.813 0.313,0.156 10 false *a
*a Matchmark


Align the matchmarks and install the rear drive shaft assembly to the rear axle hub and bearing assembly.

NOTICE:
·

Do not damage the rear disc brake dust cover sub-assembly.

·

Do not damage the rear drive shaft outboard joint boot.

·

Check that there is no foreign matter on the contact surfaces.

·

Do not push the rear axle carrier sub-assembly towards the outside of the vehicle any further than necessary.




Hide 48790 3.TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY

Hide 48720A 4.TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY

Hide 48740F 5.TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY

Hide 48258C 6.INSTALL REAR LOWER COIL SPRING INSULATOR

Hide 48231B 7.INSTALL REAR COIL SPRING

Hide 8.CONNECT REAR STABILIZER LINK ASSEMBLY

Hide 890C0A 10.CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

Hide 48720A 14.INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY

Hide 48740F 15.INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY

Hide 48790 16.INSTALL REAR UPPER CONTROL ARM ASSEMBLY

Hide 48738 17.INSTALL REAR SUSPENSION ARM COVER

Hide 17430 18.INSTALL TAIL EXHAUST PIPE ASSEMBLY (for RH Side)

Hide 19.INSTALL REAR WHEEL

Hide 48740F 20.INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY

Hide 23.INSPECT FOR HYBRID TRANSAXLE FLUID LEAK

Hide 24.INSPECT FOR EXHAUST GAS LEAK (for RH Side)

Hide 25.INSPECT AND ADJUST REAR WHEEL ALIGNMENT