| When the vehicle speed increases in the automatic display mode, the panoramic view and wide front view screen or the two-side view screen remains displayed, without switching to the navigation screen.
|
Parking assist ECU
|
|
| The screen display timer function does not operate if the manual display mode is selected.
|
Check the screen display timer function
|
-
|
| Parking assist ECU
|
|
| The estimated course lines do not match the vehicle width extension lines when the steering wheel points straight ahead.
|
Check the steering wheel installation angle
|
|
| Adjust steering angle
|
|
| Camera view adjustment (calibration)
|
|
| Parking assist ECU
|
|
| Estimated course lines stop moving before the steering wheel is turned fully left.
|
Steering angle setting (calibrate stored maximum steering angle)
|
|
| "!" is displayed and estimated course lines are not displayed.
|
Check that the back door is not open
|
-
|
| Parking assist ECU
|
|
| Radio and display receiver assembly*1
|
|
| Multi-display assembly*2
|
|
| Estimated course lines are not displayed.
|
Check the panoramic view monitor screen display mode settings (Check if the estimated course lines display is set to off)
|
|
| Parking assist ECU
|
|
| "!" is displayed.
|
Store the steering angle sensor steering neutral point
|
|
| Diagnostic mode - Signal connection check (CAN check)
|
-
|
| Check that the electric parking brake system is operating normally
|
-
|
| "!" remains displayed after the steering neutral point is stored.
|
Adjust steering angle
|
|
| Steering sensor
|
|
| Parking assist ECU
|
|
| "!" is displayed and all the buttons on the screen are grayed out.
|
Camera view adjustment (calibration)
|
|
| Adjust steering angle
|
|
| Check that the navigation system or audio and visual system is operating normally
|
-
|
| Radio and display receiver assembly*1
|
|
| Multi-display assembly*2
|
|
| "!" is displayed and all the buttons on the screen are grayed out even after parking assist ECU initialization has been completed.
|
Parking assist ECU
|
|
| Check that the navigation system or audio and visual system is operating normally
|
-
|
| Radio and display receiver assembly*1
|
|
| Multi-display assembly*2
|
|
| Guide lines and buttons are not displayed on the panoramic view and rear view screen display screen.
|
Check that the back door is not open
|
-
|
| Check if the luggage compartment light turns on and off normally (If not, refer to Lighting System (Interior) - Problem Symptoms Table)
|
|
| Parking assist ECU
|
|
| "CHK" is displayed for an item on the Vehicle Signal Check screen.
|
Diagnostic mode - Signal connection check
|
|
| Blind spots in image.
|
Ensure no door is opened
|
-
|
| Camera view adjustment (calibration)
|
|
| Camera boundary lines are poorly connected.
|
Camera view adjustment (calibration)
|
|
| Estimated course lines are displaced.
|
Camera view adjustment (calibration)
|
|
| Adjust steering angle
|
|
| All buttons on the panoramic view monitor are continuously grayed out
|
Refer to Navigation System*3
|
|
| Refer to Navigation System*4
|
|
| Refer to Audio and Visual System*5
|
|