Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.
Stop the engine.
Using SST, Recover the refrigerant from the A/C system using a refrigerant recovery unit.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
4.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
5.
DISCONNECT SUCTION HOSE SUB-ASSEMBLY
Remove the bolt and disconnect the suction hose sub-assembly.
NOTICE:
Do not use a screwdriver or similar tool to disconnect the suction hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
Text in Illustration
*a
Disconnect tube by hand
Remove the O-ring from the suction hose sub-assembly.
6.
DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
Disconnect the air conditioning tube and accessory assembly.
NOTICE:
Do not use a screwdriver or similar tool to disconnect the air conditioning tube and accessory assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
Remove the O-ring from the air conditioning tube and accessory assembly.
7.
DISCONNECT HEATER WATER INLET HOSE
Using pliers, grip the claws of the clip and slide the clip to disconnect the heater water inlet hose.
HINT:
Collect the engine coolant in a container.
8.
DISCONNECT HEATER WATER OUTLET HOSE
Using pliers, grip the claws of the clip and slide the clip to disconnect the heater water outlet hose.