Home › Engine / Hybrid System › 1KD-FTV LUBRICATION › OIL PUMP(w/o Glow Plug Controller) › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009600 1KD-FTV LUBRICATION _0052401 OIL PUMP(w/o Glow Plug Controller) A

1KD-FTV LUBRICATION  OIL PUMP(w/o Glow Plug Controller)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the injection pipes, clean them with a brush and compressed air.



PROCEDURE

Hide 11.INSTALL PUMP DRIVE SHAFT PULLEY

a.

Install a new O-ring to the fuel supply pump.


b.

Temporarily install the fuel supply pump with the nut.


c.
A070711
1.26,1.177 1.094,1.875 1.094,1.875 1.604,1.573 true 0.802,1.885 1.125,2.073 0.323,0.188 10 false SST

Using SST, hold the crankshaft pulley and tighten the nut.

SST
09213-58014  
09330-00021  

Torque:
64 N*m (650 kgf*cm, 47 ft.*lbf)


d.

Install the No. 2 camshaft timing pulley flange and pump drive shaft pulley with the 4 bolts.

Torque:
31 N*m (316 kgf*cm, 23 ft.*lbf)


e.
A036609

Using a dial indicator, check the thrust clearance of the pump drive shaft while moving the pump drive shaft pulley back and forth.

Standard thrust clearance:

0.15 to 0.55 mm (0.00591 to 0.0217 in.)


HINT:

If the clearance is not within the specified range, remove and reinstall the fuel supply pump and pump drive shaft pulley. Then repeat the step above.



Hide 25.TEMPORARILY INSTALL ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER (w/ EGR Cooler)

Hide 30.INSTALL NO. 2 INTAKE AIR CONNECTOR BRACKET (w/ EGR Cooler)

Hide 31.INSTALL ELECTRIC VACUUM REGULATING VALVE ASSEMBLY (w/ EGR Cooler)

Hide 32.INSTALL NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY

Hide 36.INSTALL MANIFOLD STAY WITH VACUUM SWITCHING VALVE (w/ EGR Cooler)

Hide 38.INSTALL NO. 1 COMPRESSOR MOUNTING BRACKET (w/ Air Conditioning System)

Hide 48.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53.PERFORM REGISTRATION

a.

Perform registration of the injector compensation codes (See page Engine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM(w/ EGR Cooler)>REGISTRATION).