When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the injection pipes, clean them with a brush and compressed air.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.DRAIN ENGINE OIL
4.DRAIN ENGINE COOLANT
5.REMOVE ENGINE ASSEMBLY
6.REMOVE NO. 1 TIMING BELT COVER
7.REMOVE TIMING BELT
8.REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY
9.REMOVE NO. 2 IDLE PULLEY ASSEMBLY
10.REMOVE GENERATOR ASSEMBLY
11.REMOVE GENERATOR BRACKET
12.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
13.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET (w/ Air Conditioning System)
14.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND COOLER
15.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY
16.REMOVE NO. 2 FUEL PIPE
17.REMOVE NO. 3 NOZZLE LEAKAGE PIPE
18.REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY
19.REMOVE WIRING HARNESS CLAMP BRACKET (for i-ART)
20.REMOVE NO. 2 CYLINDER HEAD COVER SUB-ASSEMBLY
21.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
22.REMOVE CAMSHAFT TIMING PULLEY
23.REMOVE NO. 2 TIMING BELT COVER
24.REMOVE ENGINE WATER PUMP ASSEMBLY
25.REMOVE VACUUM PUMP ASSEMBLY
26.REMOVE VANE PUMP ASSEMBLY
27.REMOVE CAMSHAFT POSITION SENSOR
28.REMOVE CRANKSHAFT POSITION SENSOR
29.REMOVE PUMP DRIVE SHAFT PULLEY
Remove the 4 bolts, No. 2 camshaft timing pulley flange and pump drive shaft pulley.
Using SST, hold the crankshaft pulley and remove the nut and O-ring.
30.REMOVE CRANKSHAFT PULLEY
31.REMOVE TIMING GEAR COVER
32.REMOVE INJECTION GEAR
33.REMOVE NO. 1 CRANKSHAFT POSITION SENSOR PLATE
34.REMOVE CRANKSHAFT TIMING GEAR
35.REMOVE IDLE GEAR THRUST PLATE
36.REMOVE NO. 1 IDLE GEAR
37.REMOVE NO. 1 IDLE GEAR SHAFT
38.REMOVE FUEL SUPPLY PUMP ASSEMBLY
39.REMOVE OIL PAN SUB-ASSEMBLY
40.REMOVE OIL STRAINER SUB-ASSEMBLY
41.REMOVE TIMING GEAR CASE ASSEMBLY